Laserfiche WebLink
1. After cutting free the damaged section of containment <br />pipe (no more than 7"/ 175 mm) long, slit the section of <br />pipe in half and remove. <br />2. Using a sander, coarse file or 60-80 grit Emery cloth, <br />remove surface gloss from both ends of the remaining <br />pipe. Sanded area must be a minimum of 3" (75 mm) <br />in lengths. If contaminated, clean the sanded surfaces. <br />3. Mix the adhesive with filler. Assemble and bond the con- <br />tainment sleeve coupling into place and heat cure the <br />bond. <br />4. After the repaired section has cured, pressure test the <br />system following the procedures listed in testing. <br />If damage is beyond these repair procedures, immediately <br />contact your local distributor for assistance. <br />60 <br />Jf., i 17 2017 <br />ENVIRONMENTAL HEALTH <br />DEPARTMENT <br />