Laserfiche WebLink
Note: Pin and rods are adjustable for 2", 3" and 4" sizes. Pin <br />must be in proper position for size to give correct depth of cut, <br />see figure. <br />Piping System Layout - Sump Penetration Fitting <br />Installation <br />Dualoy 3000/LCX was designed with the idea that fiberglass <br />pipe could be installed through the sumps in series. In order <br />to achieve this, sump penetration fittings are used to allow the <br />pipe to pass through the sumps to the next sump. <br />a) Typical sump penetration detail for a system piped in paral- <br />lel or at last sump of a system piped in series. <br />b) Typical sump penetration detail for a system piped in series <br />and utilizing termination tees. <br />c) Typical sump penetration detail for a system piped in series <br />using termination sleeves and jumper hose. <br />Note: Low test pressure needed if connecting tube is pres- <br />surized. <br />Note: 24 inch (600 mm) minimum width recommended on <br />dispenser sumps to facilitate series installations. <br />Cont. <br />Connect <br />Tube <br />Bonded <br />Clam- <br />shell <br />Term. <br />Test <br />Reducer <br />Bonded <br />Clamshell <br />Termination <br />Assembly <br />With <br />Test Port <br />Oo OJ \lpy <br />3000/1- <br />Dualoy 90° elbow <br />3000/LCX with 11/2" <br />bonded threaded <br />clamshell bushing <br />termination <br />tee <br />h�llow Sump <br />Penetration Fitting <br />64 <br />Jk , r I LUlr <br />ENVIRONMENTAL HEALTH <br />E'_.."..T. MENT <br />