COMPLIANCE INFO 2016 - 2018 - Laserfiche WebLink

Home Browse Search

Garrett Backus [EH] From: Garrett Backus [EH] Sent: Friday, July 01, 2016 9:46 AM To: 'Jesse Diaz' Cc: Elena K. Manzo [EH]; Kasey Foley [EH] Subject: RE: B-20 in Loves tanks - San Joaquin County - Ripon USTs Hi Jesse, Love's has approval to store and sell ASTM D6751 Standard B20 in the UST system under the conditions listed below. The ball valve shall be closed to prevent B20 from entering the piping connected to the auto side UDCs. Thank you, Garrett Backus, Ld. Sr. REHS, CUPA programs San Joaquin County Environmental Health Department 1868 E Hazelton Ave, Stockton, CA 95205 (209) 468-2986 (phone) (209) 468-3433 (fax) gbackus@sjcehd.com http://www.sjcehd.com/ This communication and any attachment may contain confidential and privileged information for the use of the designated recipient(s) named above. Distribution, reproduction or any other use of this transmission by any party other than the intended recipient(s) is prohibited. If you are not the intended recipient, please contact the sender immediately and permanently delete the original and any copies of this email and any attachments. From: Jesse Diaz [mailto:Jesse.Diaz@loves.com] Sent: Wednesday, June 29, 2016 4:05 PM To: Kasey Foley [EH]; Garrett Backus [EH] Cc: Elena K. Manzo [EH] Subject: RE: B-20 in Loves tanks - San Joaquin County - Ripon USTs My answers are below but and I need to confirm with fueling operations and Facilities Maintenance, but all the decisions will go through me. If approved I could get better clarification on our exact steps and time frames. To be honest we are getting engineered plans drawn up and currently getting bids from fuel contractors to replace all 6 diesel sumps and all the Auto UDC's/piping and put 3+1 on the auto side; which would allow us to sell diesel on every UDC on the auto side. Those plans were based on not getting approval for the UDC's and diesel sumps; not sure if they will proceed or get scrapped. I think Love's would prefer not to replace perfectly good sumps/piping and UDC's if not needed (if approved for B20). Does that mean you will not be selling any diesel fuels to cars? If approved and if we started to store B20 and the 2 UDC's on the auto side are not replaced; correct we would not sell any B20 Diesel on the auto side, by turning the ball valve off. 2. Do you have a time frame for the change out of the UDC's and dispensers on the auto side? Once approved a realistic time frame is 2 months. 3. If not, what happens to the piping? Will you temporarily close it? Monitor it? The piping sump is still monitored through the turbine sump that has a 208 sensor at the bottom of the sump and the UDC.