Laserfiche WebLink
1 <br />' GROUNDWATER SAMPLING AND ANALYSIS <br /> PROCEDURES <br />' INTRODUCTION <br />' The sampling and analysis procedures for water-quality monitoring programs are contained <br /> in this attachment These procedures were used to ensure that consistent and reproducible <br />' sampling methods were used, proper analytical methods were applied, analytical results were <br /> accurate, precise, and complete, and the overall objectives of the monitoring program were <br /> achieved <br /> 1 <br /> SAMPLE COLLECTION <br />' Sample collection procedures included equipment cleaning, water-level and total well-depth <br /> measurement, and well purging and sampling <br /> 1 <br /> Equipment Cleaning <br />' Pre-cleaned sample bottles, caps, and septa were provided by a California Department of <br /> Health Services (DHS)-approved laboratory All sampling containers were used only once <br /> and discarded after analyses were completed <br />' Before the sampling event and between each event, all equipment to be placed in the well or <br /> to come in contact with groundwater was disassembled and cleaned thoroughly with <br /> detergent water, steam cleaned with tap water, and rinsed with deionized water Any parts <br />' that may absorb contaminants, such as plastic pump valves or bladders, were cleaned as <br /> described above or replaced The water-level sounder was washed with detergent and rinsed <br /> with distilled water before use in each well The rinse water was stored in 55-gallon drums <br />' on site pending proper disposal <br /> Water-Level, Phase-Separated Hydrocarbon,and Total Well-Depth Measurements <br /> Before purging and sampling were performed, the depth to water, phase-separated <br />' hydrocarbon(PSH) thickness, and the total well depth were measured using an electric <br /> sounder, a bottom-filling clear LuciteTM bailer, and/or an oil/water interface probe The <br /> electric sounder, manufactured by Slope-Indicator, Inc , is a transistorized instrument that <br />' uses a reel-mounted, two conductor, coaxial cable that connects the control panel to the <br /> sensor Cable markings are stamped at 1-foot intervals An engineer's rule was used to <br /> measure the depths to the nearest 0 01 foot The water level was measured by lowering the <br />' sensor into the monitoring well A low-current circuit is completed when the sensor contacts <br /> the water, which serves as an electrolyte The current is amplified and fed across an indicator <br /> Iight and audible buzzer, signaling contact with water A sensitivity control compensates for <br /> I <br />