Laserfiche WebLink
22 August 2011 <br /> AGE-NC Project No. 11-1934 <br /> Page 3 of 6 <br /> 2.2.1. Piping <br /> There are manually actuated pneumatic waste oil 1-inch diameter steel pipes [22CCR <br /> §66265.192(k)(2)(C&D)] used to transport fluid to the AST. The pipes are attached to the <br /> tank for ease of avoiding spills when the pneumatic system is running and are therefore not <br /> considered more than a transport mechanism from the collection point. <br /> 2.2.2. Pump <br /> A pump [22CCR§66265.192(k)(2)(C&D)] is not attached to the AST. Facility approved <br /> waste transport technicians remove waste oil utilizing truck mounted hose and pump <br /> equipment for draining the AST. <br /> 2.3. STORAGE <br /> Vehicle waste oil [22CCR§66265.192(k)(8)] is stored within the AST. Waste oil specific <br /> gravity is approximated at 0.054 pounds per foot cubed (Ib/ft3).The AST operating capacity <br /> is 480 gallons. <br /> 2.4. VISUAL INSPECTION <br /> A visual inspection [22CCR§66265.192(k)(9)] of the tank and its affiliated pumps, piping, <br /> ancillary equipment, interior surface and exterior surface, if present at the time of the <br /> inspection, did not reveal signs of leaks, corrosion, weld cracks or breaks or scrapes in <br /> coating which may cause a release from the tank system. There were no discrepancies <br /> noted at the time of the AST visual inspection. Figure 3 shows the top and north side views <br /> of the tank. A visual assessment summary is included as Table 3. <br /> 3.0. SECONDARY CONTAINMENT <br /> The waste tank is double walled and has a 110% secondary shell for containment of a spill <br /> from the primary. The AST top and north side views are shown on Figure 3. <br /> 3.1. WASTE OIL TANK (AST) DESIGN <br /> The manufacturer of the AST was not identifiable by tank marking or Facility documents <br /> but is considered by industry standard as a bench top tank style. The primary and <br /> Advanced GeoEnvironmental,Inc. <br />