COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

DOREIE CH s 'af[All 7IR, 9ta A11-1 1xAa3R, 3�th,aR1f±9R�,�.Ah,E�`J+I A#LkCWaflIR,) ��(iThI � 2643M'NMAR)J)o A newly installed screw conveyor should run idle for 2 hours and run with load for 8 hours before being put into use. Prior to commissioning, in addition to compliance of installation with technical requirements, inspection shall be carried out on the following items: The fasteners between connecting pieces shall be checked to ensure secure and safe connection. They shall be subject to regular maintenance to prevent looseness; The electrical signal and control device as well as their connection shall be checked to ensure normal service; Start the motor and observe whether the rotation direction of the rods is correct; The following work should be conducted during commissioning: The screw conveyor should be stable and reliable and the fastening pieces have no sign of looseness. After 2 hours' run, the bearing temperature should be less than or equal to 40°C with good lubrication and sealing. No oil leakage or abnormal noise happens to the reducer and the electrical appliances and couplers are safe and reliable. It should enter normal use if all going well where attention should be paid to: The screw conveyor should be started up with no load, that is to say, it should be started with no materials in the shell. Materials may be fed in the machine only after the startup. At the initial feeding of the screw conveyor, the feed speed should be gradually increased to the rated delivery capacity and the feedstock should be uniform, otherwise, the delivery 42