Laserfiche WebLink
DVRL'i 1 ri <br />Ma�i19*3T1f9a/tAPR i��PQ ca <br />Prior to commissioning, in addition to compliance of installation with technical requirements, <br />the following inspections shall be carried out: <br />Each fastener shall be checked to ensure it is firmly tightened; <br />During crusher operation: <br />The screw of each component shall be checked to ensure it is tightly fixed; <br />The belt shall be checked to ensure its tightness degree is proper; <br />The knife edge of crusher shall be checked to ensure there is any gap or blunt gap, which, if <br />any, shall be sharpened with the knife disassembled; <br />The electrical signal and control device as well as their connection shall be checked to ensure <br />they are correct; <br />The motor shall be started up to check to ensure the operation direction of crusher rotor and <br />the rotation direction of crusher screw are correct; <br />The operators shall not put the hands into the parts operating at a high speed to avoid <br />accident; <br />The general power shall be cut off during equipment cleaning; <br />Check if the motor is overheating, Should shutdown to check problem if it was. <br />18.5 )JR-j1I ffl INTRODUCTION TO BLADE SHARPENER <br />18.5.1 Xf: ILLUSTRATION <br />; 7J IlTJ i A-!� rim -TMW#J177Mt M**1 *ffl:#7 A -Mo f <br />The knife sharpener, which is auxiliary equipment used for crusher sharpening rather than <br />main equipment, is an optional item for users, who shall choose the installation place based <br />on the actual situation of plant and arrange a separate electrical wiring for control <br />18.5.2 Zz AY: THE FOLLOWING INSPECTIONS <br />SHALL BE CONDUCTED DURING THE OPERATION OF KNIFE <br />SHARPENER: <br />60 <br />