Laserfiche WebLink
WL,j7gga*4pa��p® CH <br />�F fp] �f�c, �FJA i T7i A)JAFIfe <br />f1rI ft0)J14011T�AE:RMESEit- M**101-t7Jlv±EEAI T-11�QATaI YRLh7Jli'AP—PJ <br />o <br />Procedures : First, Install the blade, the blade edge extending table 10-15mm, blade knife to <br />come into contact with the school knife, so that the blade straight line parallel with the rail . <br />Press and release the knife blade on stage right after the open magnechuck switch, and check <br />suction, and then to the rotary knife blade lock knife sets the desired angle and then grinding <br />a little gap between the blade and transferred, Open the grinding traverse the switch to open <br />the trial grinding mill feed at the wheel when there see a little spark, the coolant on foot in <br />place, take the knife back and forth 1-2 times, adjusting automatically take the knife block <br />automatic collision give .After Sharping blade grinding blade, the knife rack in machine tool <br />on the left. Sticks to the blade burr, workbench demagnetization, take out the blade. <br />Lubrication points and rail should be refueled twice per class .To do the cleaning work in <br />time. <br />lbPl�j (301:51301 A) o <br />The coolant of the machine is metal grinding fluid. ( 301 or 301 A). <br />)1f *f4M:41—#f Abrasive blade selection <br />63 <br />#U <br />I <br />IRI <br />91Up (MA E) <br />M A Pj <br />Name <br />Material <br />Characteristic <br />Grinding <br />Hardness <br />Organization ( <br />Binding <br />material <br />Size <br />concentration) <br />agent <br />No. <br />t] -if, <br />a <br />7J PK ( $110) <br />TL(GC) <br />30-60 <br />H -K <br />'� <br />V(A) <br />� <br />Hardness <br />Grinding <br />80-180 <br />R2-ZR1 <br />( ) <br />Loose <br />alloy <br />(rough <br />Cutter <br />grinding) <br />J -L <br />blade <br />(R3-ZR2) <br />7J (*) <br />TL(GC) <br />46-80 <br />J -L <br />VLLarge <br />V(A) <br />Grinding, fine <br />(R3-ZE3) <br />pores <br />grinding) <br />JR <br />46-80 <br />50-75 <br />B(S) <br />63 <br />