Laserfiche WebLink
BODE' M <br />CH <br />53�A)�tkVMV (8*8 4R <br />Should handle the amount of work and non-ferrous materials contained in the specific <br />circumstances to adjust the belt speed and direction of rotation of the rotor eddy current <br />(determined by observing the rotor motor fan motor rotation) and speed, sorting through the <br />small particles of material worn (8 * 8 under mesh sieve material), the magnetic rotor rotation <br />and the belt should run in the opposite direction; sorting large bulk materials (8 * 8 mesh <br />sieve feeding), the magnetic rotor rotation should be run in the same direction with the belt . <br />#aTX7 ( k7) na, %c*nMf;M <br />The device is equipped with a rotor bearing temperature measurement devices,when the <br />bearing temperature reaches temperature which is the set point temperature, then there is <br />alarm indicator (red) flashes and beeps an alarm, you should immediately shut down, and <br />check equipment;if there is no alarm indicator,the device continues to operate, bearing <br />temperature continues to rise to a value of bearing overheating thermostat setting, the <br />temperature overheat indicator (yellow) lights up, the device automatically close <br />30.4 AW (QAP V)� BELT DEVIATION ADJUSTMENT METHOD <br />D_W&o <br />Belt deviation adjustment method: belt adjustment bolt is located inside the cover <br />plate (shown diagram position), when adjust the belt it must remove the cover plate here <br />128 <br />