Laserfiche WebLink
D. Results of Testing/Servicing <br /> Software Version Installed: 2 <br /> Com ete the following checklist: <br /> s ❑ No* Is the audible alarm operational? <br /> ❑ No* Is the visual alarm operational? <br /> Y ❑ No* Were all sensors visually inspected, functionally tested,and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ * If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> YA operational? <br /> ❑ Yes C� No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) ❑ Sump/Trench Sensors; ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑Yes; ❑ No. <br /> ❑ `i'es ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i_e. no <br /> �N/A mechanical overfill prevention.valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s) and operating properly? If so,at what percent of tank capacity does the alarm trigger? % <br /> ❑ Yes* No Was any monitoring equipment replaced? If yes,identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> Yes* ❑ No <br /> Was_4quid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> Urf'r-oduct; GKater. If yes, describe causes.in Section E,below. <br /> ❑ Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br /> *In Section E below, describe how and when these deficiencies were or will be corrected. <br /> y <br /> E. Comments: <br /> -e r-_ )C-0 (,R „�. p' S -eP7 E-1f <br /> u1'.1 16 <br /> , a I'l,1 15�_ Oct Q �-1 a -0 <br /> hen <br /> { �1 #- <br /> T IP rIP "'l__1 u_S CM S-I 2a � Ut � R Y” car �, C.� t.�t r P s � /' �£� t,l <br /> J e✓ - ( A; S r`O.Q r')S�E'®f— 5;,Ldy?7 rJ S <br /> 119 Q Lk sz> Q yfi CC 1 t t l l f'.l <br /> Page 2 of 3 03/01 <br />