COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

4.2 ARM (Association of Rotational Molders) Standards: Low Temperature Impact Resistance (Falling Dart Test Procedure) 4.3 ANSI Standards: B-16.5 Pipe Flanges and Flanged Fittings 4.4 OSHA Standards: 29 CFR 1910.106 Occupational Safety and Health Administration, Flammable and Combustible Liquids 4.5 UBC CODE: Uniform Building Code 2006 Edition 4.6 IBC CODE: International Building Code 2009 Edition 4.7 CBC Code: California Building Code 2010 Edition RECEIVED 4.8 NSF/ANSI Standard 61 — Drinking Water System Components (Type II resin) JUL 2 8 2014 4.9 40 CFR -264.193 ENVIRONMENTAL HEALTH 5. Submittals DEPARTMENT 5.1 Drawings and Data: The manufacturer's shop drawings shall be approved by the engineer or contractor prior to the manufacturing of the tank(s). Data and specifications for the equipment shall include, but shall not be limited to the following. 5.2 Contractor shall submit for review sufficient literature, detailed specifications, and drawings to show dimensions, materials used, design features, internal construction, weights and any other information required by the ENGINEER for review of storage tanks and accessories. 5.3 Information to be included with submittals are specified below: 5.3.1 Shop drawings for the tanks shall include as a minimum the following: a) Service Conditions: Chemical environment and temperature. b) Statement that fabrication shall be in accordance with ASTM D 1998, where applicable. c) Sizing and description of the fittings and accessories for each tank that are to be supplied by the tank manufacturer. d) Layouts and assembly schedules for each tank identifying the location and elevation from the bottom of the tank for all connections and appurtenances supplied by the tank manufacturer. 5.3.2 Resin - A copy of the resin data sheet from the resin manufacturer for the tank is to be supplied and the tank manufacturer is to certify that it will be the resin used in the manufacture of the tank. Verification may be required if the resin is to be FDA or NSF 61 listed. 5.3.3 Wall thickness - Prior to the manufacture of the tank the designed wall thickness audit is to be supplied based upon 600 psi hoop stress (ASTM D 1998) @ 100 degrees F. (Note: See 9.1.2 for chemicals being stored above 100 degrees F) 5.3.4 Tank restraint — If supplied, the drawings and calculations for the system are to be provided. Note: Wet stamped or site specific drawings and calculations may be required.