Laserfiche WebLink
5.3.5 Supporting information on fittings and accessories to be supplied; heat system, <br />insulation, mastic coating, etc. <br />5.4 Technical Manuals: The tank manufacturer's "Guideline for Use & Installation" is to be <br />submitted for review. <br />5.5 Installation certificate: Once installed the installer is to certify that the tank system has been <br />installed according to the tank manufacturer's Guidelines for Use & Installation. <br />5.6 Manufacturer's warranty <br />5.7 Manufacturer Qualifications: The manufacturer is to have rotationally molded polyethylene <br />tanks based upon ASTM D 1998 utilizing Type I and Type II resins for the last 10 years. <br />5.8 Factory Test Report: Upon completion of the tank the manufacturer's inspection report is to <br />be supplied for each tank. <br />a. Verification of wall thickness (See 10.5) RECEIVED <br />b. Impact test (See 10.3.1) <br />c. Hydrostatic test (See 10.6) <br />d. Verification of fitting placement (See 10.2.4) JUL 2 8 2014 <br />e. Visual inspection (See 10.7) <br />f. Verification of materials <br />ENVIRONMENTAL HEALTH <br />6. Service Conditions DEPARTMENT <br />Note: The tank color will be based upon the chemical application and UV exposure of the installation. Tank color is to <br />be natural, black or opaque white. <br />Table I — Service Conditions <br />Tank # Chemical Concentration / <br />Stored Specific Gravity <br />Tank <br />Location <br />Inside / <br />Outside <br />Operating Fitting <br />Temperature Material <br />(Temperature of <br />chemical) <br />Gasket Bolt <br />Material Material <br />7. Chemical Compatibility <br />7.1 Chemical compatibility shall be according to the following chemical resistance guides: <br />Compass Publications - <br />Pruett, Kenneth M., "Chemical Resistance Guide for Plastics" <br />Pruett, Kenneth M., "Chemical Resistance Guide for Metals and Alloys" <br />Pruett, Kenneth M., "Chemical Resistance Guide for Elastomers III" <br />7.2 These references shall be considered as general guidelines only. In many cases, <br />combinations of these chemicals are used in such a way that only the customer (by testing <br />molded product samples) can make a determination in regards to acceptability. <br />Note: Contact the manufacturer for applications that are not listed below. <br />