COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

Unified G STOCKTON DISTRIBUTION OPERATING PROCEDURES Janitor Cieanin Modules. 10. Sign into your assignment then proceed to the directed slot in the corresponding pick module. Confirm that you are in the right location via the check digit. 11. Begin traveling throughout the module. Clean all debris and place any damage inside a gray tote. Deduct the damage from inventory using WD- and place the gray tote on the conveyor belt. 12. Place good orphan cases back into their pick location. 13. Remove shrink wrap/straps from pallets in the pick slots. Place shrink-wrap in clear bags and the straps and wood in the black garbage bags. 14. The aisle should be neat and orderly as you go through it. 15. Proceed with your next assignment. Cleaning Docks. 16. Sign into your assignment then proceed to an exit door nearest you. You will confirm your location with the check digit on the label above the exit door. 17. Use a broom to sweep the perimeter. If you see a trash can that needs dumped, you are required to dump it into your dumpster. Once the perimeter is done use the sweeper to sweep the main dock area. 18. Once you're done with the sweeper, clean it inside and out, park it in assigned area, and plug it back in so it can charge. 19. The dock should be neat and orderly as you go through it. 20. When finished, you will be sent to door 147 to empty your dumpster in the trash compactor, and to dispose your cardboard in the proper receptacle. 21. Proceed with your next assignment. Collect Pallets. Customer 999004 You will need a reach fork to perform this job. Sign into your assignment. Upon arriving at the pick slot, you will need to verify that it is the correct slot by saying the "check digit" number located on the rack above or to the side of the slot. Go from slot to slot removing empty pallets from slots. Continue stacking the pallets up until your reach approximately 18-20 pallets high. Call out 1 every time that you clear a pallet slot; call out "zero" when you reached the maximum number of pallets within your stack, stage full stack at door 50 to be sorted. The last slot called out as zero will give you the travel time from last slot to door way and back to next assign slot. Keep in mind super high production will be reviewed against the video tape to verify that you took the stage pallet trip to door 50 (pallet staging area). In the module, you will be directed to the floor level of the pallet returns. Please empty the pallets from level 1, 2, and 3 for that specific location. i.e. Vocollect will direct you to Al -221 1, call out the check digit and quantity, empty this location along with A2-2211, and A3-2211. Continue the assignment until all pick slots have been completed. This is accomplished by following the Vocollect voice selection system. Proceed with your next assignment. RECEIVED MAY 2 2 2014 ENVIRONMENTAL HEALTH DEflAHT EN1- 11/28/11