Laserfiche WebLink
• <br />STEP 3 <br />Pushing back <br />exi sti ng bo Its <br />Protect pipe <br />against any <br />damage <br />STEP 4 <br />STEP 5 <br />• <br />COMPLETE ❑ <br />Before starting work, ensure all fuels <br />and flammables have been removed. <br />Test/monitor your LEL's and ventilate. <br />Push the bolts back into the backfill. <br />Most bolts move backwards easily. <br />DO NOT DAMAGE THE SUMP WALL! <br />Properly protect your piping from power <br />or sharp tools. DO NOT DAMAGE PIPE! <br />COMPLETE �1) <br />Proceed to grind your walls clean of any <br />paint, gel -coat, adhesives or sealants <br />until open fiberglass is clearly visible <br />3 INCHES AWAY FROM THE HOLE, <br />all the way around. <br />MANDA,ORY L-6-6- m P -LET� --E-1 <br />SECURE ALL CONDUIT LINES BY <br />BRACKETING THEM TO AT LEAST ONE <br />RIGIDLY CONNECTED CONDUIT OR <br />THE RISER. DO NOT ALLOW CONDUIT <br />ENDPOINTS TO MOVE OR ACT AS A LEVER. <br />FLAT WALLS: Dry fit the body on your pipe and <br />use a marker to outline the fittings position on the <br />wall. The curved flange will not be used. <br />CURVED WALLS: Dry fit the body and the curved <br />flange and use a marker to mark a large stripe <br />across the sump wall, body and flange. Also <br />outline the fittings position when dry fit. <br />STRIPE MARK <br />mark across the <br />0of <br />wall and all <br />r= <br />components <br />DRY FIT <br />ONLY <br />SECURE ALL CONDUIT LINES BY <br />BRACKETING THEM TO AT LEAST ONE <br />RIGIDLY CONNECTED CONDUIT OR <br />THE RISER. DO NOT ALLOW CONDUIT <br />ENDPOINTS TO MOVE OR ACT AS A LEVER. <br />FLAT WALLS: Dry fit the body on your pipe and <br />use a marker to outline the fittings position on the <br />wall. The curved flange will not be used. <br />CURVED WALLS: Dry fit the body and the curved <br />flange and use a marker to mark a large stripe <br />across the sump wall, body and flange. Also <br />outline the fittings position when dry fit. <br />