Laserfiche WebLink
• <br />STEP 8 <br />• <br />BEAD ADHESIVE <br />HEAV LY ON ALL SEAMS <br />31600 DEGREES AROUND <br />F rFTNG BEFORE <br />CLEANUP <br />PIPE CLAMP <br />SEAT. YOUR FITTING <br />�- A E BODY TOGETHER. <br />COMPLETE ❑ <br />Stick this assembly to the wall and apply a strong pressure to push the halves <br />together and against the wall, aligning the marked stripe. When joined, rotating <br />the fitting back and forth helps. <br />Adhesive should ooze from every seam and joint while pushing the fitting halves <br />together against the pipe and wall. Clean the face of the fitting with acetone or <br />equivalent and remove excess adhesive. You want the fitting clean enough to <br />remove the pipe clamp after the fitting cures. <br />Use provided pipe clamp to secure the fitting halves to each other. More adhesive <br />may ooze from the split seams as you tighten, re -clean as necessary. <br />LET THE FITTING(s) CURE DCS NOT CAUSE PIPE <br />OR CONDUITS TO MOVE OR TWIST DURING CURE <br />After a full cure, remove the pipe clamp holding the two fitting halves together. If it is <br />too difficult to remove and appears to be bonded in place, do not force it off. <br />STEP 9LAKE TESTING (Water Testing): <br />After the F -Series Retrofit -S Fittings are installed and have fully cured, water level test to a <br />maximum of 2" above the highest penetration fitting on the sump. Follow local regulations. <br />13 ii -F -Series -Retrofit -S -13B <br />