INSTALL_2013 - Laserfiche WebLink

Home Browse Search

restricting delivery of flow to the tank at least 30 minutes before the tank overfills, provided the restriction occurs when the tank is filled to no more than 95 percent of capacity; and activate an audible alarm at least five minutes before the tank overfills." Response: The overfill prevention method is the external audible/visual alarm set at 90% of the tank capacity. The applications have been revised accordingly and included with this resubmittal. 2. Items 35, 36 and 38 on page T-5 of the plans are Bravo brand penetration fittings for double-walled sumps. The manufacturer's cut sheet provided was for single-walled fittings. Please provide the double-walled cut sheets for the Bravo penetration fittings. Response: The correct cut sheets are included with this resubmittal. VERBAL COMMENTS PROVIDED BY: ARIS CACAPIT, REHS/TELEPHONE: (209)468-3453 2680 REYNOLDS RANCH PARKWAY, LODI,CALIFORNIA 95240 COSTco Loc. No. 10911 OUR JOB No. 14573 Monitoring Plan: 1. Page No. 2 of 2, Section VII-line 490-66: Secondary Containment would not need to be tested every six months because it is under continual 24-hour monitoring. No. 2 does not need to be checked. Response: The application has been revised per comments and is included with this resubmittal. 2. With the Section X-you put the "Overfill alarm set at 90% for overfill protection." What it should say 'Audio Visual Alarm for overfill protection" insert audible visual alarm after the 90%for line 490-71 Response: The application has been revised per comments and is included with this resubmittal. 3. 1 noticed that in the monitoring plan you list the Veeder-Root 323 sensors as the sensor to be installed. On Page 8 of the Install Application, Section 1, it looks like 208 sensors but the parts list also lists 323, so maybe the 208 should be switched to 323 Response: The applications have been revised to identify the use of the 323 sensor, not the 208. 4. Alarm Panel: The model according to your monitoring plan - maybe on page 8 (of the Install Application) we should also put in the model, TLS350R, because that should also match up with the parts list on the full-size site map. Response: The Veeder-Root model number has been updated on all applications. 5. Page T-3 of the Site Map Section C, there is a #51 which refers to, according to the parts list provided, a fitting for a round sump. However, according to the site plan, that sump is not round but has a flat side to it. You should check on that Response: The actual point-of-entry for the product line will occur at the round part of the existing sump. Only the bottom 24-inches of the existing sumps are flat sided (polysided). The upper portion of the sump is round. See Elevation View D for point-of-entry of the product line. 12919c.039.doc