Laserfiche WebLink
_ D. Alternate construction for new underground storage tanks containing motor vehicles fuel [Section 26331. <br />(1) <br />Monitoring and resoonse plan [Section 26341. <br />(2) <br />Underground storage tank composed of.... <br />(a) Fiberglass reinforced plastic. <br />(b) Cathodical Ly protected steel. <br />_ <br />(c) Steel clad with fiberglass reinforced plastic. <br />_ <br />(d) Other material that complies with section 2631 and 2632. <br />(3) <br />Floor of Leak interception and detection system constructed on a firm base and sloped to a <br />_ <br />collection sump (use of membrane liners comply with section 2631 (d) (6) requirements.) <br />(4) <br />Access casings installed in the collection sump of the secondary containment system with <br />_ <br />backfill in the interstitial space. The access casing shall meet all of the following: <br />_ <br />Designed and installed to allow the liquid to flow into the casing. <br />_ <br />Sized to allow removal of collected liquid and able to withstand all anticipated applied <br />stresses. <br />Constructed of material that will not be structurally weakened. <br />Screened along entire vertical zone of permeable material. <br />Capable of preventing leakage of any hazardous substance from the casing. <br />Extend to the ground surface and covered with a locked waterproof cap. <br />Capable of meeting S.J. Co. PHS-EHD Well Standards. <br />_ <br />Leak interception and detection system shall prevent the Leaked hazardous substance from <br />entering ground water. <br />14. INTERSTITIAL SPACE MONITORING <br />d <br />A. Visual monitoring [Section 2632 (c) (1)] <br />(a) Exterior surface and floor beneath tank monitored by direct viewing <br />(b) Daily visual inspections <br />(c) Liquid level in tank to be recorded at time of inspection <br />(d) If liquid observed around or beneath primary tank, owner will determine if an unauthorized release <br />has occurred. <br />B. Mechanical or electronic monitoring [Section 2632 (c) (2)] <br />(a) Continuous monitoring system) connected to an audible and visual alarm system. <br />Monitoring equipment to be installed <br />Model Number: <br />Sensor Type: Vapor _ Liquid Both. <br />Sensor/Panel specifications. <br />_ Location(s) for sensors= <br />Tank: Piping: <br />Dispenser: <br />C. Monitoring and response plan submitted (Section 2632 (d) (1) & (2)]. <br />15. r/� Any special accessories, fittings, coatings, or Linings not inherent within the initial design of the 1° tank or <br />double-wall UST. [Section 2631 (b)] <br />A. Approved by a nationally recognized independent testing organization. <br />B. Demonstration of integrity with the primary and/or secondary contairment- <br />0 <br />