Laserfiche WebLink
Aug-31-04 04:54pm From-Gettler- Inc +9166311317 T-357 P.006/009 F-269 <br /> Installing the Dispenser Pan. Sensor <br /> This section describes the hardware,requirements,wiring guidelines,and procedures <br /> for installing the Dispenser Pan Sensor with Dispenser Control Interface. <br /> Installation Hardware <br /> The Stand-Alone Dispenser Pan Sensor with Dispenser Control Interface comes with <br /> the following installation hardware: <br /> For applications which requite UL listing: <br /> © Veeder-Root Non-Discriminating Stand-Alone Dispenses Pan Sensor with <br /> Dispenser Control Interface <br /> Part No. 847990-001 (Float-Switch Type) <br /> ❑ Veeder-Root Discriminating Stand-.Alone Dispenser Pan Sensor <br /> with Dispenser Control Interface <br /> Pan No.847990-002(Differentiating type) <br /> For applications which require cUL listing: <br /> 0 Veeder-Root Non-Discriminating Stand-Alone Dispenser Pan Sensor with <br /> Dispenser Control Interface <br /> Part No.847970-001 (Float-Switch Type) <br /> O Veeder-Root Discriminating Stand-Alone Dispenser Pan Sensor <br /> with Dispenser Control Interface <br /> Pan No.847970-002(Differentiating Type) <br /> For both: <br /> • 1 wiring Kit(Part No. 330020-024) <br /> d Installation Instructions <br /> Important Mounting brackets are required and mast be ordered separately. Use of Veeder-Root <br /> Universal Mounting Kir(Part No.330020-012)is recommended. <br /> Installation Requirements <br /> Before you install each Dispenser Pan Sensor,consider the following important <br /> requirements: <br /> 1. The sensor should rest in the cup or lowest point of the dispenser pan. <br /> 2. It is recommended that the sensor be mounted in a true vertical position to ensure <br /> proper operation of the sensor. <br /> 3. Ensure that there will be enough room to pull the sensor straight out of the pan if <br /> service is required. <br /> 5 <br />