Laserfiche WebLink
Aug-31-04 04:54pm From-Gettler-0 Inc +9166311317 is T-357 P.007/009 F-269 <br /> Dispenser Junction Box Requirements Installing the Dispenser Pan Sensor <br /> l <br /> Dispenser Junction Box Requirements <br /> Installing Dispenser Control Interface <br /> 1. The dispenser junction box must have at least one unused threaded conduit open- <br /> ing,either 1/2",3/47',or I"trade size. <br /> 2. The opening may be anywhere on the junction box,as long as sufficient clearance <br /> exists around the opening for installation of the Dispenser Control Interface. <br /> Important When determining the installation location of the Dispenser Control Interface on the <br /> junction box, choose a location in which the Dispenser Control Interface will nor <br /> interfere in any way with the operation of the dispenser or in maintenance or service <br /> access. <br /> Wiring Dispenser Control Interface to Dispenser <br /> The following requirements must be met before attempting to wire the Dispenser <br /> Control Interface to a dispenser. <br /> 1, Be sure AC power to the dispenser junction box is OFF before attempting to open <br /> the junction box and wire the dispenser control interface to the dispenser. <br /> The following applies to both installing and wiring the Dispenser Control Interface: <br /> AflJL WARNING <br /> Before installing this device,turn OFF power to the system. <br /> Electrical shock resulting in serious injury or death may result if <br /> power is on during installation and the device is improperly installed. <br /> O High voltages are present in the dispenser junction box. Be sure to <br /> tum OFF all power before opening the junction box. More than one <br /> disconnect may be required to completely de-energize the box. Failure <br /> to comply with this warning may result In personal injury, property <br /> Oloss,and equipment damage. <br /> + � Do not use any electric tools in the area of the dispenser island.Since <br /> �! the island is considered a Class I, Group D hazardous Location, <br /> failure to comply with this warning could result in an explosion. <br /> Important w 2. The junction box must have sufficient volume to accommodate the extra wiring to <br /> be installed,and must comply with the National Electric Code,Article 370-16. <br /> The required volume for any dispenser can be calculated using the information in <br /> Table I. <br /> 6 <br />