Laserfiche WebLink
{ <br /> WINTER WARNING <br /> FOR COLD WEATHER AT 50OF DEGREES OR LESS: <br /> OBSERVE AND FOLLOW THE WARNINGS BELOW <br /> BRAVO SYSTEMS FF-SERIES FLANGE FITTINGS AND F-SERIES <br /> FITTINGS ARE THICKER THAN THE TYPICAL FIBERGLASS CLAMSHELLS <br /> COMMONLY INSTALLED IN FIBERGLASS PIPING APPLICATIONS. <br /> YOU MUST APPLY ADEQUATE HEAT TO THE PARTS AND BONDING <br /> ADHESIVES TO ALLOW A FULL CURE TIME DURING EXTREME COLD <br /> TEMPERATURES. FAILING TO ALLOW THE INSTALLATION TO FULLY <br /> CURE MAY CAUSE THE ADHESIVE BOND TO THE FITTING TO FAIL. <br /> JUST BEFORE EACH ADHESIVE APPLICATION <br /> IDRY FIT YOUR COMPONENTS ONE LAST TIME <br /> 1) PRE-HEAT THE SUMP TO NO MORE THAN 150°F TO ELIMINATE MOISTURE. <br /> 2) PRE-HEATING COMPONENTS IN EXTREME COLD WEATHER IS CRITICAL: <br /> > PRE-HEAT THE FIBERGLASS FITTING THOROUGHLY TO -100°F <br /> > PRE-HEAT THE ADHESIVE TO ~800F. DO NOT HEAT CATALYSTII <br /> 3) DO NOT ASSUME THE ADHESIVE IS CURED BECAUSE IT HAS HARDENED ON THE <br /> EXTERIOR. IT MAY ONLY BE A CURED "CRUST" IN THIS TEMPERATURE AND ANY <br /> MOVEMENT OR WATER TESTING MAY CAUSE DELAMINATION AND TOTAL FAILURE <br /> OF THE BOND. <br /> 4) DO NOT ADJUST, MOVE, SHIFT OR OTHERWISE DISTURB THE <br /> SUMP, FITTINGS OR PIPING DURING THE CURING PROCESS. <br /> 5) YOU MUST ENSURE A FULL CURE BEFORE WATER TESTING. FOLLOW <br /> YOUR ADHESIVE INSTRUCTIONS FOR TEMPERATURE GUIDELINES. <br />