Laserfiche WebLink
STEP D1) Get your injection syringes and your adhesive kits ready. See Page 3 or 9. <br /> � FOR BRAVO DOUBLEWALL <br /> SUMPS ONLY. <br /> While fittings are curing, <br /> keep the SVA-BARB <br /> ® installed on the schrader <br /> valve. This will relieve any <br /> SVA-BARB pressure. <br /> STEP 012) Mix your approved adhesive kit with the provided fiberglass filler. Load your syringe <br /> by placing the tip in the can of mixed adhesive and drawing it up. PURGE THE AIR FROM THE <br /> SYRINGE TIP (Pg. 9) <br /> STEP D3) Quickly inject the adhesive into the Adhesive Injection Port OUTSIDE THE SUMP <br /> -FIRST- , which is located at the top of each fitting body. The paste should flow into the interior <br /> channel and seep out along the conduit. When the exterior is complete, Inject the same amount of <br /> adhesive into the port INSIDE THE SUMP -SECOND-. (Fig. D3) <br /> DO T ATTEMPT TO INJECT BOTH SIDES AT ONCE <br /> INJECT > INJECT <br /> ADHESIVE > ADHESIVE <br /> OUTSIDE INSIDE <br /> FIRST SECONDAdhesive <br /> Injection <br /> complete <br /> Fig. D3 <br /> USE ONLY ROBROYTM PVC-COATED CONDUIT <br /> or any brand hot-dip galvanized conduit <br /> bead with bead with <br /> gloved finger gloved finger <br /> Outside of Sump Inside of Sump <br /> T ) Run adhesive around the joints and bead with a gloved finger and let cure. (Fig D3) <br /> 10 ii-F-Series-1X-SS-D-11A <br />