Laserfiche WebLink
rgjnn t =e Fitting & FRP wall <br /> A.1) Prepare your fittings by identifying the parts. Clean the surfaces of all fittings with <br /> trichloroethylene or acetone to remove any contamination. Hand sand with 60-grit sandpaper if <br /> necessary. Do not lay them on dirt, water, debris or other contaminated surfaces. When dusting off, <br /> use a shop brush, chip brush or compressed air. Do not use rags, cloth or cloth-like material <br /> - r <br /> DRY-FIT YOUR FITTINGS TO BE SURE THAT THEY ALIGN <br /> PROPERLY WITH THE FALL YOUR VAPOR LINES WILL NEED. <br /> r DO NOT PLAN HOLE SAW CUTS ON UNEVEN SURFACES. <br /> FLAT PANELS ONLY. CAREFUL OF CORNERS AND EDGES. <br /> M R ro ,� YOU CAN NOT MOUNT FITTINGS ON ROUND SURFACES <br /> A.2) Dust off Sump walls (inside and out) and drill your pilot holes centered on the planned fitting <br /> locations using a 1/4" Drill bit. Proceed when done to cut your holes with appropriate size hole saw <br /> with 1/4" centralizer. See the table of fittings and hole saw sizes below. Hand-sand the rough <br /> edges inside and outside made by the hole saw. <br /> [DO NOT RILL, t; T OR IMP ANYWHERE ON THE F11TING <br /> DO NOT GLUE/SEAL THE DOUBLE <br /> H E <br /> TIC Tj WA:LLTINTERSTICE ATFTER YOUR <br /> T S OL IS CU <br /> OLE IS ® ®® <br /> HOLE SAW SIZE CHART <br /> 4-1/2" for F-32-TS-D ° <br /> 5-1/2" F-43-TS-D <br /> 8" F-64-TS-D Fig. A3 <br /> A.3) The Sanding kit is recommended (Page 3, sanding gun <br /> sold seperately) with an air powered source to lightly abrade each <br /> hole until the surfaces are flat and even (Fig. A3). <br /> Follow the T-FS-SAND-KIT Installation Instructions. <br /> DO NOT OVERGRINDII DoubleWall - MAINTAIN A MINIMUM WALL THICKNESS OF 3/8" INCH <br /> 6 ii-F-Series-TS-D-13A <br />