Laserfiche WebLink
- DO NOT ALLOW ADHESIVE TO FILL THE <br /> 'IIS CHANNEL OR TEST PORT AREA <br /> ONLY I, <br /> ONLY <br /> / Carefully apply mixedFIREN <br /> adhesive to the flange <br /> B.7) The Flange (Item B) should be installed to the inside of the sumpafter adhesive has been <br /> applied as shown. (Fig. 137) NOTE THE ORIENTATION <br /> OF THE INJECTION AND TEST PORT. (Fig. X) / erstitial Test Port <br /> Only on Flange) <br /> Adhesive <br /> The Adhesive Injection Port on the fitting body ' Injection <br /> must be at the 12-o-Clock or North Position, <br /> Port <br /> towards the top of sump (opening). (Fig. X) <br /> (Fig. X) . <br /> The Interstitial Test Port on the Flange / /j Secondary <br /> must be at 12-o-Clock or North Position; � �%��� ,��/f, Pipe <br /> towards the top of sum o g. ) ,% /� Test Pt <br /> P (opening). (Fig. X <br /> (DOUBLE WALL SUMPS ONLY) (Only o <br /> Main body) <br /> i <br /> Fig. B7 FB <br /> Item B <br /> i <br /> (Flange) <br /> Fill & _ <br /> Bead <br /> Here <br /> 360° <br /> Adhesive Adhesive <br /> Item A <br /> (Main' body) <br /> OUTSIDE OUTSIDE <br /> OF SUMP OF SUMP <br /> ) Bead the adhesive 3600 around the fitting edge where it meets the sump wall (Fig. 138). <br /> Then again allow to cure following the pipe manufacturers adhesive instructions. SKIP TO STEP D. <br /> 8 ii-F-Series-TS-D-13A <br /> r; <br />