INSTALL_2014 B100 - Laserfiche WebLink

Home Browse Search

Flying J Travel Plaza #618, 1501 N. Jack Tone Rd., Ripon CA, 95366 —SR0068444 Will the sensor in the sump shut down the pumps in the injection building when an alarm is trigged? Second response received: NEF cutsheet and Affirmative Statement of Compatibility provided in this submittal. Specified sump sensor is a non-discriminating sensor programmed for positive shut down when in alarm. Refer to note 14fPP5. Upon reviewing the cut sheets for the NEF Bio Diesel Equipment Transition Sump, a model number was not listed. The third party listing information provided from the manufacturer is not a valid UL file number. The ULC file number for NEF products is EGV1/7.MH30126. The Bio Diesel Equipment Transition Sump is not listed under this file number. Provide the model number for the Bio Diesel Equipment Transition Sump and a valid third party specific file number for the approved listing. What type of hydrostatic monitoring fluid will be used within the interstitial space of the Bio Diesel Equipment Transition Sump? F 5. A completed Unified Program Consolidated Form (UPCF) for Underground Storage Tank information was not submitted. First response received: Form to be submitted with this resubmittal. The completed form has double walled vent piping transition sump checked. A double walled vent piping transition sump is not shown on sheet PP1.1. Only a concrete pad that supports the black iron piping transition below finished grade. Also the product piping is listed as a pressurized system. How will the biodiesel piping have a mechanical line leak detector installed? Second response received: Sump is shown on detail 01fPP1.1. Biodiesel line is k conventional suction. Form corrected and attached. I Corrected form was received. 6. Manufacturers' cut sheets for tanks, piping, and equipment (e.g., monitoring equipment, overspill containment device, overfill protection device, etc.) were not submitted. Also include the Affirmative Statement of Compatibility by each manufacturer to ensure that B100 is compatible with their products. i First response received: Cut sheets to be submitted with this resubmittal. Cut sheets were not submitted for the type of Ameron piping, transition sump in the injection i building, and the vent transition sump. A cut sheet for a double walled spill container was E provided and was not the one listed on the proposed installation plans. y Second response received: Additional Cut sheets to be submitted with this resubmittal. Additional cut sheets were received. A single walled spill container will be utilized for the fill and vapor risers as listed on the plans. 7. Buoyancy calculations wet signed and stamped by a Professional Engineer were not t submitted for the UST. I 4 r