COMPLIANCE INFO 2010-2013 - Laserfiche WebLink

Home Browse Search

D. Results of Testing/Servicing i • Software Version Installed: Com lete the following checklist: (X)Yes ❑ No* Is the audible alarm operational? (X)Yes ❑ No* Is the visual alarm operational? (X)Yes 4 No* Were all sensors visually inspected, functionally tested,and confirmed operational? (X)Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? )Yes ( )No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g, modem) (x)N/A operational? ( )Yes (x)No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment ( )N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut-down? (Check all Haat apply) ❑ Sump/Trench Sensors; 3 Dispenser Containment Sensors. Did you confirm Rositive shutdown due to leaks and sensor failure/disconnection? ❑Yes; d No. N/A O Yes (x)No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i,e, no N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s)and operating property? If so,at what percent of tank capacity cbes the alarm trio cr7 % ( )Y"* (x)No Was any monitoring equipment replaced? If yes,identify specific sensors, probes,or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below. (x)Yes* ( )No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ Product; II Water. If yes,describe causes in Section E, below. (x)Y'es ❑ No* Was monitoring system set-Lip reviewed to ensure Cropur Settings? Attach set tire orts, if a licable x Yes ❑ No* is all monitoring equipment oerational per manufacturer's s ecifications? * In Section E below,describe how and when these deficiencies were or will be corrected. E .Comments: Reprogrammed Sensor Names to Correspond to there physical location . A small amount of water was found in piping sump 92 approximately 3 to 4 oz. also found water in piping sump #6 approximately 14/2 to 2 Gals in the non-sensor side of sump removed water. A small amount of water was found in piping sump #S; S to 10 oz Mothering 9yetcm Certtacntion Pngc 3 nr4 12/t17 in-,rank Gaining/ SIR 11'quipment: ( x) Check this box if tank gauging is used only for inventory control. ( ) Check this box if no tank gauging or SIR equipment is installed.