Laserfiche WebLink
• i <br />RPD JACKET PUAW-MOTOR REPLACEMENT POLICY <br />Red Jacket EXTRACTA motors are of explosion -proof construction, undergo rigid quality tests during manufacture, and carry the <br />Underwriter's Laboratories Listing, The factory service department maintains a replacement stock of pump -motor assemblies at the <br />factory and strategic shipping points across the nation. Warranty failures should be returned to the factory in Ddvenport, freight pro -paid. <br />Warranty failures will be replaced at no charge when received. (Replacement pump -motor assemblies carry the same warranty as new <br />units.) On a few pumps, models P3381, P50CI and P33A1 which were built in 1956, the pump -motor assembly cannot be removed. <br />On these models the entire extractable portion of the pump must be replaced. <br />Red Jacket 4" diameter pump/motor assemblies are Interchangeable except that the lengths <br />vary depending on the horsepower. When changing the horsepower, be sure to check the <br />length so that proper clearance off tank bottom Is maintained. UMP replacement instructions <br />can be found In RJ publication #5161 and Instruction sheet #041-296. <br />ELECTRICAL SERVICE INFORMATION <br />-----No.- <br />ModelF3/4 <br />_ Volts__ <br />Max. Load <br />Amps <br />Locked <br />Rotor Amps <br />Winding Resistance Ohms1__ <br />Blk-Yellow Red -Yellow 81ack-Red <br />Min. <br />Max. <br />200 <br />250 <br />4.0 <br />-edP33R1 <br />13 <br />7.4-8.3 <br />16.1-17.9 <br />23.5-26.2 <br />P75S1 <br />200 <br />250 <br />6.5 <br />22 <br />3.6-4.1 <br />9.6-10.6 <br />13.2-14.7 <br />P150S1 <br />200 <br />250 <br />10.5 <br />42 <br />2.0-2.1 <br />5.2-5.6 <br />7.2-7.7 <br />X3PI50S1 <br />200 <br />250 <br />9.1 <br />42 <br />2.0-2.1 <br />5.2-5.6 <br />7.2-7.7 <br />X5P150S1 <br />200 <br />250 <br />10.5 <br />42 <br />2.0-2.1 <br />5.2-5.6 <br />7.2-7.7 <br />Failure to follow all Instructions In proper order can cause personal Injury or death. Read all <br />Instructions before Installing. All Installation work must comply with local code require- <br />ments. If no other codes apply, the latest Issue of the National Electrical Code should be <br />followed. <br />Installation of Red Jacket pumps should be performed only by personnel who are trained and <br />qualified to do so. <br />