INSTALL_1997 - Laserfiche WebLink

Home Browse Search

%ell E Interconnecting Containment Sumps Alter a GeoFlex Pipe section has been coupled, take the pipe section to the trench and insert Into the containment sump through the Flexible Entry Boot. Make sure the band clamp of the Entry Boot has been removed or sufficiently loosened to permit the pipe to pass through the rubber boot. Be sure to tighten the band clamp of the Entry Boots after the installation process has been completed. , Note: Prior to connecting the Pipe Coupling to the Pipe Fitting make sure of the following: (1) the Test Boots have been installed to the end of the pipe section (See the installation instructions below.) L t Sump • (2) If pipe crossovers are to be included in the piping layout, the Installation of the Crossover Supports should be made at this time. (See the installation Instructions below.) (3) Read the 'Pipe Coupling Connection' Instructions carefully on the following page before any coupling to fitting or adapter connections are made. After one end of the flexible pipe section has been connected to a containment sump take the other end of the pipe section to the next containment sump In series and repeat the same connection procedure. After both ends of a flexible pipe section have been connected to the containment sumps, inspect the length of pipe between containment sumps to make sure It is oasitinnad nrnnem, in Installing Crossover Supports Crossover Supports should be used at all flexible piping crossovers and installed over the flexible piping at any rigid piping or conduit crossovers. These two piece supports are installed to both the upper and lower flexible pipe sections. They must be installed before backfill begins. They are designed to provide a flat crossover surface for the upper pipe and also allow for even backfill compaction around both flexible pipes. To install, align upper and lower support as shown in illustration and fasten together using the supplied clips. Be certain not to scratch piping while Installing clips. Installing Test Boots For GeoFlex Piping Installations the Test Boots must be installed to the ends of each flexible pipe section in order to provide a means of air pressure integrity testing the interstitial space of the flexible pipe. After all pipe sections have been inserted into the containment sumps and before Pipe Couplings are connected to the Pipe Fittings or Pipe Adapters, the Test Boots should be installed. The Test Boot has an outlet opening located on the bottom for connection of the Connector Tubes and Test Tubes which are used for performing an air pressure Integrity test as described on page 22 of this product manual. Step #1 Remove both band clamps from the Test Boot before Installing the rubber boot over the end of the coupled flexible pipe section. Sump After integrity testing has been completed, the Test Boots can remain interconnected if product flow is desired to run to the tank sump. If product flow is desired in all sumps then one antl of the Connector Tube In each junction type Dispenser Sump should be disconnected from the Test Boot to permit the interstitial space of the GeoFlex Piping to drain Into the containment sump. Comply with the following three step installation Procedures for proper installation of the Test Boots. Step #2 From Inside the containment sump install the Test Boot over the Installed Pipe Coupling. Step #3 Center the Test Boot over the end of the outer containment jacket with the smell outlet facing downward. Then install and tighten band clamps.