INSTALL TANK TOP SUMP AND UDC REPLACEMENT PLAN

Home Browse Search

GUIDELINES FOR TLS - 350R SYSTEM SET-UP (Revised 06/01 ) ONLY AUTHORIZED VEEDER-ROOT DISTRIBUTORS MAY PERFORM SYSTEM SETUP ** OUTPUT RELAY SETUP TABLE C Relay Type....................Standard Overfill High Level SYSTEM SETUP RelayOrientation...........Normall Closed Nominal Low pelivery Limit Limit Maximum or Y Full Volume Assignment Method Tank Alarms tanks...Overfill Capacity Product Limit U of � of Label Limit Station Header.....................Must include address, city, and state alongwith 6-digit SAP site number. g Manufacturer g (Gallons) Limit (Gallons) Actual Actual Actual Ca ncit Manufacturer Shift Start Times..................T!me 1 : 6:00AM (Shift Times 2, 3 & 4 will not be used.) OUTPUT RELAY SETUP (Facilities without PLLDs) Reference Table A (Gallons) Tank Tank Capacity Actual Capacity RORO locations may choose optional times to suit business needs. Relay Type....... (Gallons) Gallons ............Standard Capacity Capacity (Gallons) Periodic Test Warnings........Enabled (Days = 21) Relay Orientation..........Normally Closed4000 150 700 95 98 XX = gallons XX = gallons Periodic Test Alarms............(Days = 28) Assignment Method......ln Tank Alarm...Each Tank...High Water, Low Fuel (Per Tank Model Chart) (Per Tank Model Chart) Annual Test Warnings..........Disabled Assignment Method......Liquid Sensor Alarms...by Sensor; Fuel, High Liquid, Low Liquid XX = gallons XX = gallons System Security Code..........6-digit SAP location number Assignment Method Wire CL Alarms Sensor.....Fuel, High Liquid 6000 250 1000 95 98 (Per Tank Model Chart) (Per Tank Model Chart) (NOTE: System Key Pad Security Switch Must be Enabled:52 position #1 Closed) PLLD LINE DISABLE SETUP (Facilities with PLLDs) Reference Table A 8000 300 1500 95 98 XX = gallons XX = gallons COMMUNICATIONS SETUP DATA FOR THE POLECAT RS232 COMM BOARD - (HUGHES) (Per Tank Model Chart) (Per Tank Model Chart) Assignment Method......ln Tank Alarm...Each Tank...High Water, Low Fuel XX = gallons XX = gallons Baud Rate = 9600 Assignment Method......Liquid Sensor Alarms...by Sensor; Fuel, High Liquid, Low Liquid 10000 400 1500 95 98 (Per Tank Model Chart) (Per Tank Model Chart) Parity = ODD RS232 Security code must left disabled! Stop Bit = 1 12000 500 1500 95 98 Data Length = 7 XX = gallons XX = gallons TABLE A (Per Tank Model Chart) (Per Tank Model Chart) COMMUNICATIONS SETUP DATA FOR THE RUBY RS232 COMM BOARD 15000 500 2000 95 g8 XX = gallons XX = gallons Relay Output Assignments for Alarm Activation and Shutdown (Per Tank Model Chart) (Per Tank Model Chart) Baud Rate = 9600 XX = gallons XX = gallons Baud Parity = NONE 20000 600 2500 95 98 (Per Tank Model Chart) (Per Tank Model Chart) Stop Bit = 1 TANKS PIPING CONTAINMENT Data Length = 8 The RS-232 port needs to be connected to the VSAT's Port 3 if the site has already been set-up and configured to communicate SINGLE DOUBLE SINGLE DOUBLE SUMP DISPENSER INTERSTITIA Nominal Capacity < This is the generic tank size. via the satellite (Consult Polecat Administrator if you have questions regarding this connection @ 281-874.7834). WALL WALL WALL WALL REQUIRED CONNECTION EQUIPMENT AREA AREA AREA TANKS TANKS PIPING PIPING Low Product Limit < When tank guage float reaches this level of product in tank, the product line will be disabled. - RS - 232 Serial Port Satellite (VSAT) Board 3.0 gph LINE FAILURE YES YES Delivery Limit < A warning will sound that product has reached this level in tank. Delivery order should be confirmed. Compatible Category 5 Shielded Communications Cable w1D8-25 Connectors. ,2 gph LINE SINGLE FAILURE NO NO Shut down for that tank will occur at low product limit if delivery not received. PINS: (2 = SEND) (3 = RECEIVE) (7 = GROUND) (20 = DTR straight through end to end) Overfill Limit < This is the first level alarm setting which will track tanks filled to 95% of manufacturer's actual capacity. Laptop computer programmed with V-R diagnostics or Pro-Com software or use Hyper-Link to test cable, VSAT board and TLS 350. i gph LINE SINGLE FAILURE NO NO Communications Break-Out Box or Mini-Tracker also highly recommended for trouble-shooting of communications problems. High Level Limit <This is the second level alarm setting which will track tanks filled to 98% of manufacturer's actual capacity. IN-TANK SETUP .2 gph PROGRAMMED NO NO Full Volume <This is the gallon amount to be programmed into the Veeder-Root which reflects manufacturer's actual capacity for tank as published on the location-specific tank chart. Follow normal setup procedures. Use the following information as a standard PERIODIC ALARM Product Labels....................Refer to Table B -Check POS labeling and verify compatibility Maximum or Label < This is the gallon amount to be programmed into the Veeder-Root which reflects manufacturer's actual Product Code................. .Refer to Table B .2 gph TANK FAILURE NO NO Volume Limit capacity for tank as published on the location-specific tank chart. This number must match the number entered for Full Volume. This is not the generic, nominal capacity number. 9 ( ) HIGH WATER YES YES Water Warning.........2' 1" for ETOH blended fuel High Water Alarm.....3" (2" for ETOH blended fuel) Maximum or Label Limit......Refer to Table C (Tank actual capacity per manufacturer's tank chart) LEAK ALARM YES YES POLECAT COMMUNICATIONS SET-UP PROTOCOLS Overfill Limit........................Refer to Table C SUDDEN LOSS NO NO Relay Type...................Standard High Level Limit........... .......Refer to Table C Relay Orientation..........Normally Closed Delivery Limit.......................Refer to Table C LOW LEVEL YES YES Assignment Method......In Tank Alarm...Each Tank—High Water, Low Fuel Low Level Limit..................Refer to Table C LINE SHUTDOWN ON THIS ALARM CONDITIONI _ Assignment Method......Liquid Sensor Alarms...by Sensor; Fuel, High Liquid, Low Liquid Leak Alarm Limit........50 Gallons LINE SHUTDOWN ON THIS ALARM CONDITIONI SENSOR ALARMS YES YES NO Assignment Method......3 Wire CL Alarms...by Sensor.....Fuel, High Liquid Sudden Loss limit......50 Gallons — Tank Tilt........If probe is mounted in the center of the tank tilt should be set at 000.00. If the probe is not in the center follow instructions in the most recent Veeder-Root set-up manual for calculating tank tilt. D4 NOT USE TANK TILT TO MATCH THE MANUAL STICK READINGS. SINGLE TANK Must be selected and assignment of alarms must be associated with the appropriate tank and sensors. IN MOST CASES THE TLS-35OR SHOULD NOT MATCH THE STICK. IN TANK ALARMS High Water ----------- Water level in tank has reached the programmed point. Low Fuel -------------- Fuel level in tank has dropped below the low level limit. IN-TANK SETUP Periodic Leak -------- A periodic leak is a .2 gallon per hour test. Leak Min Annual ......................50% LIQUID SENSOR Fuel -------------------- This applies to a sensor which is installed in the sump or interstitial area of the tank. Leak Periodic Test Type...........25% High Liquid ----------- Applies to the Brine sensor in the interstitial area of the bank. Periodic Test Type....................Standard Low Liquid ------------ Applies to the Brine sensor in the interstitial area of the tank. Annual Test Fail........................Disabled Periodic Test Fail......................Disabled 3 WIRE This sensor is installed in the containment sumps and will not shut the pump down for water unless the water Gross Test Fail..........................Disabled CURRENT LOOP reaches the HIGHEST point on the sensor. It will then shut the line down with a "High Liquid"alarm and fuel alarm. Annual Test Averaging............-Off Periodic Test Averaging............Off Tank Test Notify........................Off TABLE B Tank Test Siphon Break............Off Delivery Report Delay...............I Minute; Manlfolded tanks only...5 mins or greater Meter Data.................................Yes PRODUCT LABEL TANK * PRODUCT End Factor.................................None/O (for BIR only) LOCATION CODE Cal Update.................................Immediate IN-TANK AUTO LEAK TEST SETUP DATA UNLEADED REGULAR 1 1 Leak Test Method.......................All Tanks Leak Test Frequency...........-.....CSLD ( .2 gph test) UNLEADED PLUS 2 2 Gross Test Auto-Confirm............Disabled Report Only.................................Disabled SUPER UNLEADED 3 3 Test Early Stop...........................Disabled DIESEL 4 4 Leak Test Report Format............Disabled KEROSENE 5 5 Changes made to existing locations must be phoned in to Polecat Admin . PRESSURIZED LINE LEAK DETECTOR SETUP 0.10 GPH Test............................Enabled/Repetitive — from the location and communication must be confirmed . 0.20 GPH Test............................Enabled/Repetitive Manifolded Tanks Example , Shutdown Rate...........................3.0 GPH only Low Pressure Shutoff.................Yes TANK * PRODUCT Low Pressure..,...........................5 PSI PRODUCT LABEL LOCATION CODE 2.0" DIA Length..........................Actual (>100 ft.) Default is 501 feet and must be changed RECONCILIATION SETUP (Automatic monthly printout) UNLEADED REGULAR 1 1 Automatic Daily Closing..............Default (2:00am) Automatic Shift Closing...............Not used UNLEADED REGULAR 2 1 Periodic Reconciliation Mode......Monthly Periodic Reconciliation Alarm.....,Disabled SUPER UNLEADED 3 3 NOTE: Please refer to your State and Local Regulations regarding when a reconciliation report must be printed. You must SUPER UNLEADED 4 3 program Periodic Reconciliation for Rolling if you are required to generate a report on a given number of days. *Tank Location -This is the preferred tank layout as it applies the TLS-350 channels. With manifolded tank applications this will not be possible, however, the product order should be maintained. "Fhese drawings and specifications are the confidential and _. ® APPROVALS proprietary property of Shell oil Products US and shall not be ® Shell Oil Products US CALIFORNIA copied, reproduced, disclosed, or used without Shell Oil DISTRICT MANAGER 0 G 0AI_� �-®RNlA U . S.T. STANDARDS Products US written authorization. They ore intended as contract documents for use on this specific project in ❑ AREA TECHNICAL MANAGER DOUBLEWALL FIBERGLASS TANKS conjunction with its issue date and are not suitable for use on MOtiva Enterprises LLC a different project or of a later date. N GRAPHIC SCALE TERMINAL MANAGER VEEDER — ROOT SPECIFICATIONS 1 1011/31 /021 CLARIFICATION /CHANGES jjR 12700 Northborough Drive SCALE: SAP/WIC # DATE: DRAWN: REQUESTED BY: Q Shell Oil Products US. All Rights Reserved 2002 REV DATE DESCRIPTION OF REVISION BY APP Houston TX 77067-2508 ENGINEER NONE 800062 03 MAY 2002 f2ABAG0 HOVLAND E01031500