Laserfiche WebLink
D. Results of Testing,/Sen icingo <br /> Software Version Installed; <br /> nm lets the follawin checklist: <br /> 1.S Yes ❑ No* I Is the audible alarm o erational? <br /> Yes ❑ No* Is the visual alarrn operational? <br /> Yes 13 No* Were all sensors visually inspected, functionally tested, and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> 2� N/A operational? <br /> Yes ❑ NO For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply)dd Sump/Trench Sensors;A Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection?)&Yes; ❑ No. <br /> ❑ Yes ❑ No*- For tank systems that utilize the'monitoring system as the primary tank overfill warning device (i.e. no <br /> Af N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fillpoint(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger? <br /> ❑ Yes* ,a No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E, below. <br /> ❑ Yes* 2'-No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) El <br /> Product; C3 Water. If es, describe causes in Section E,below. <br /> Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports, if applicable <br /> Yes ❑ No* Is all monitoring a ui ment operational per manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page 2 of 3 03101 <br />