INSTALL_1987 - Laserfiche WebLink

Home Browse Search

FIL_ GC3.1 Construction Nediun For) General Conaltlons 3-3-33 3CS Genera: Conditions ry-, '.; (Rtgelder - Insur l GC-i • GENERAL CONDITIONS 1 DEFINITIONS 1.1 '?CAE": Pscifi. Gas and Electric Compal. 1.2 "Bidder": Parry or parties submitting a proposal for the specified work. 1.3 "Constructor": PGSE's Vice President-General Construction or his authorized representative. 1.4 'Materials Department": PG&E's `tanager of Materials Department or his authorized representative. . .��••�'�,.4, i, N '•S.T S'.r, 'EogSneer : PG&E s Vice President-Engineering or his authorized representative. 1.6 "Contractor": Party or parties entering into a contract with PC&E for the work. 1.7 "Contract": This agreement, between Fr&E and Contractor for the work under the Specification. 1.8 "Specification": ME's Specification which Includes these General Conditions, the Specific Conditions, and ocher documents specified under the Contents page -L-. 1.9 "As Directed." "As Required," "As Permitted." "approved," "acceptable." "Satisfactory," or similar terms shall mean by or to Constructor. 1.10 "Work": Labor, materials. and requirements specified. 1.11 "Approved Equivalent": An item approved by Engineer as being acceptable to PG&E as a substitute for a specified item. Additionai substitution requirements are specified in Division 1. 2 PROPOSALS 2.1 GENERAL: Proposal shall he submitted on the attached Proposal Cora, enclosed in a sealed envelope marked "Proposal" with the title of the work, and delivered to the address stated In the Proposal Form on or prior to the time invited. The signed Specification and drawings Shall be forwarded with the Proposal. PG&E reserves the right to refect any or all proposals. 2.2 VISIT TO WORK SITE. Bidder shall make arrangements with Constructor to visit the work site. The Proposal shall be based on full knowledge of all conditions that would affect the cost and conduct of the work. 2.3 TL`ME: Contractor shall perform the work In as short a time as practicable consistent with good workmanship and without overtime, unless otherwise specified. Time quoted by Bidder for completion of the work will be an laportant consideration in making the award of contract. The time so stated will be incorporated In the contract. Time is of the essence. 3 DRAsII[CS. SP_CIFICATION AND INFORMATION 3.1 DISCREPPA:ICIES: Specification and drawings are complementary and are intended to be consistent with each other. Contractor shall report to Constructor any discrepancies or errors. 3.2 DLMZ NSIONS: Contractor shall obtain at the work site the necessary dimensions and not rely on the drawings for dimensions which tic into the existing work. No claim will be honored which is a result of failure to comply with this provision. 9b 3.3 CONSTRUCTICN DRAWINGS: As soon as possible after award oL contract, approved construction drawings will be provided Contractor for use in the performance of the work. Bidding drawings shall not be used for construction purposes unless authorized in writing by Constructor. 3.4 ESTIMATED QUANTITIES. WEIGHTS. OR DATA: Quantities, weights, or data made available to Contractor by PG&E for preparation of his proposal or for performance of the work shall not relieve Bidder or Contractor of the responsibility to satisfy himself through investigations as to conditions affecting the cost and performance of the work. Estimated quantities and information submitted are the beat available at the time, however. PG&E assumes no responsibility for the correctness of such information or for Contractor's conclusions drawn therefrom, F11.ECM/105