INSTALL TANK TOP UPGRADE PLAN 1997

Home Browse Search

76 PRODUCTS MONITORING SYSTEM STANDARD FOR VARIOUS TANK AND PIPING CONFIGURATIONS VEEDER ROOT SYSTEMS A (') B C , D (') E F G H I J 76CFS 1 2-GASOLINE 2-GASOLINE 2-GASOUNE 2-GASOLINE 2-GASOLINE 2-GASOUNE 2 GASOUNE 2-GASOLINE 2-GASOLINE 2-GASOLINE 2-GASOUNE I-DIESEL 1-DIESEL 1-DIESEL 1-DIESEL t-�5' 0 TANK 1-0IESEL D W PIPING D/W PIPING 1-DIESEL 1-WASTEWATER S W PIPING D W PIPING S W PIPING 5 W PIPING D/ PIPING D W PIPING D W PIPING S FlBERGLASS D/W FRP TANK D/W PIPING D/W PIPING DESCRIPTION PART NO. S/STEEL TANK D/W TANK D/W STEEL TANK S/STEEL TANK D/W STEEL TANK D/STEEL TANK S/W FIBERGLASS D/W FRP TANK D/W STEEL TANK (QTY) (QTY) (QTY) (QTY) (QTY) (QTY) (QTY) (QTY) (QTY) (QTY) (QTY) TLS-350 CONSOLE WITH PRINTER _ 847080-022 0 1 0 0 1 1 1 1 1 1 0 TLS-35OR CONSOLE WITH PRINTER 848290-122 0 0 0 0 0 0 0 0 0 0 1 TLS-350R CONSOLE WITH PRINTER WITHOUT BIR 848290-022 1 0 1 1 0 T 0 0 0 0 0 RS-232 INTERFACE MODULE 329362-001 1 1 1 1 1 1 1 1 1 1 1 DISPENSER INTERFACE MODULE 330280-201 0 0 0 0 1 0 0 0 0 0 0 CSLD SOFTWARE ASSUMES 24 HR SITE 330160-002 1 0 0 1 1 0 0 1 1 1 1 0 OVERFILL ALARM 790091 -001 0 0 0 0 0 0 0 0 0 0 1 ALARM ACKNOWLEGMENT SWITCH 790095-001 0 0 0 0 0 0 0 0 0 0 8-INPUT INTERSTITIAL MODULE 847490-102 1 1 1 1 1 1 1 1 1 1 2 SUMP SENSOR 794380-208 3 3 3 2 3 2 3 2 2 2 12 INTERSTITIAL SENSOR-10 FRP TANK 794390-409 0 3 3 0 0 0 0 0 2 3 3 - INTERSTITIAL SENSOR-4 FRP TANK 794390-401 0 3 3 0 3 2 0 0 0 0 1 INTERSTITIAL SENSOR-STEEL 794390-420 0 3 3 0 3 2 0 0 0 0 4-INPUT PROBE MODULE 847490-104 1 1 1 1 1 1 1 1 1 1 1 10 FOOT MAG 1 IN-TANK PROBE TANK GAUGING 847390-109 0 3 3 0 2 1 2 0 0 2 3 3 8 FOOT MAG 1 IN-TANK PROBE TANK GAUGING 847390-107 3 0 0 2 0 0 3 2 0 0 0 6 FOOT MAG 1 IN-TANK PROBE TANK GAUGING 847390-104 0 0 0 0 0 0 0 0 0 0 1 MAG PROBE INSTALL KIT-GASOLINE 849600-000 2 2 2 2 2 ? 2 2 2 2 3 MAG PROBE INSTALL KIT-DIESEL 849600-001 1 1 1 0 0 0 1 0 0 0 1 PROBE CAP AND RING KIT 312020-952 3 3 3 2 2 2 3 2 2 2 4 1 -INPUT LINE LEAK MODULE 329398-001 3 0 3 2 0 0 0 0 0 0 0 LINE LEAK DETECTOR KIT LINE PRESSURE SENSOR 847590-001 3 0 3 2 0 0 0 0 0 0 0 4-RELAY OUTPUT MODULE 847490-200 0 1 0 0 1 1 1 1 1 1 1 EXPANSION MODULE 847490-001 1 0 1 1 0 0 1 1 1 1 1 1 2 INTERSTITIAL CAP AND ADAPTER 312020-928 0 3 3 93 2 0 0 0 0 0 THERMISTOR FOR LINE LEAK DETECTION 576010-856 1 0 1 1 0 0 0 0 0 0 0 OPTION S2 ON VEEDER ROOT SYSTEMS A- 1 B- 1 C- 1 D- 1 E- 1 F- 1 G- 1 H- 1 1- 1 SUMP SENSOR 794390-208 3 3 3 2 2 2 3 2 2 8-INPUT INTERSTITIAL MODULE I tS4/4VU-IUL_L 0 1 1 1 1 1 0 1 0 1 0 1 0 0 0 NOTES (1) INSTALLATION OF VEEDER ROOT EQUIPMENT WITH SYSTEMS 'A' OR 'D' UNDERGROUND EQUIPMENT REQUIRES REGIONAL ENGINEERING MANAGER APPROVAL. (2) OPTIONS ARE FOR WHEN ENVIRONMENTAL AGENCY REQUIRES BOTH FILLS AND TURBINE SUMPS TO BE MONITORED. (3) LENGTH OF THE TANK PROBE WILL VARY DEPENDING ON THE DIAMETER OF THE TANK. A 10 FOOT PROBE IS SPECIFIED IN THE TABLE FOR THE NEW 9.5 FOOT DIAMETER TANKS. VEEDER -ROOT TLS-350 SETUP AND CONFIGURATION REQUIREMENTS FOR III IN-TANK SETUP DATA (UNOCAL STATION TYPES A,B.C,D.E,F,G,H) IV IN TANK AUTO LEAK TEST SETUP DATA (single wall tanks only) VII. OUTPUT RELAY SETUP ALL UNOCAL STATIONS. (STATION TYPES A,D,G,H) Double walled piping and/or tanks.) The following guidelines will be used at all Unocal Veeder-Root TLS-350 system Follow the normal setup procedures. Use the following information as a standard. (UNOCAL STATION TYPES B C E F G H locations as shown in the above table. Standard setup values such as thermal A.) Leak Test Method... All tanks coefficients and other site specific parameters will not be covered in this document. A. Water Warning... Gasoline- 1 .5" Diesel/Racing Fuel- 1 .0" B.) Leak Test Frequency... CSLD (0.2GPH Testing) Refer e Veeder-Root System Setup. B.) High Water Alarm... Gasoline-2.0 Diesel/Racing Fuel- 1 .5 If the station is not operating 24 hours then the in-tonk This alarm will be assigned to perform line shut down testing will be programmed for when the station is closed. A. Relay Type... Standard Manual Number 576013-880 for complete setup instructions. B. Relay Orientaion... Normally Closed C. Maximum or Label Limit... Total tank capacity as per the tank chart, C. Assignment Method, ONLY AUTHORIZED VEEDER-ROOT CONTRACTORS MAY PERFORM SYSTEM SETUP PROCEDURES. D. Overfill Limit Alarm... 90% V PRESSURIZED AND VOLUMETRIC LINE LEAK SETUP (Single wall lines only) In-Tank Alarms. (All Tanks) E. High Level Limit Alarm... 95% (STATION TYPES A.C,D) F. Delivery Limit Warning... 20% (This may also be a dealers option.) A.) 0.1 GPH Test... Enabled (Pressure LLD requires this test to be 1 . Periodic Test Alarm 3 I SYSTEM SETUP (UNOCAL STATION TYPES A.B.C.D,E,F.G,H) G.) Low Level Limit Alarm... Use the gallon amount of a 10 level from off the enabled in order to run a 0.10 GPH test. Volumetric LLD is already 2. High Water Alarm A.) Station Header..,.Must include xxxx digit Unocal site number along tank chart. This alarm will be assigned to perform line shut down. programed for the 0. 10 GPH automatically.) 3. Low Level Limit with address. H.) Leak Alarm Limit (During In-tank testing)... 56 gallons. B.) Shutdown Rate... 3.0 GPH only. This alarm will cause line shut 4. Leak Alarm Limit 5. Sudden Loss Limit Liquid Sensor Alarms. (All Sensors) B.) Shift Start Times....This option will be up to the dealer. Otherwise, This alarm will be assigned to perform fine shut down. down upon 3.OGPH testing failure. shift time #1 will be set at 6:00 a.m. (Shift times 2,3&4 will not l.) Sudden Loss Limit (During In-tank quite time)... 50 gallons. C.) Pumpside Test (VLLD)... Enabled only if containment is NOT be utilized.) This alarm will be assigned to perform line shut down. being monitored with a sump sensor. i .) Fuel Alarms. C.) Periodic 0.2GPH Test Warnings... Enabled (Days=25). Single wall tanks J.) Tank Tilt... If probe is mounted in the center of the tank, then the tank tilt D. Wait Mode... Temp. Meas. (If the system has 0 thermistor installed.) only will be set at default 0.00. If the probe is not centered in the middle of the Vol. Change (If the system doesn't have a thermistor installed.) D.) Periodic 0.2GPH Test Alarms... Enabled (Days=28). tank, then follow the instructions in Section 8.D.3 of the Setup Manual for E.) NBP Partner... Enabled (This is required if the station has mechanical Single wall tanks only. This alarm will be assigned to perform line shut down. calculating tank tilt. 00 NOT USE TANK TILT TO MATCH THE MANUAL blenders or if the station has single wall lines.) E.F.� Annual 0. 1GPH Test Warnings... Enabled (Days=340). Single wall tanks only. STICK READING. IN MOSF CASES THE TLS-350 SHOULD NOT MATCH THE STICK. VI OUTPUT RELAY SETUP (ALL SYSTEMS EQUIPPED WITHOUT LINE LEAK Annual 0. 1GHP Test Alarms... Enabled (Days=360). Single wall tanks only. K.) Leak Minimum 0. 1GPH Annual,.. 10% (Set as per local regulatory codes.) This alarm will be assigned to perform line shut down. L.) Periodic 0.2GPH Test Type... Standard DETECTION-UNOCAL STATION TYPES B,E,F,G,H) G. System SecurityCode... Enabled - The six digit number will be at the M. Annual O. iGPH Test Fail... Disabled A. Relay T e,.. Standard y g N. Periodic 0.2GPH Test Fail... Disabled choosing of the programming contactor. B. Relay Orientaion... Normally Open 0. Gross 3.OGPH Test Fail... Enabled C. Assignment Method. P. Annual 0.1GPH Test Averaging... Off In-Tank Alarms. (All Talnks) II COMMUNICATION SETUP DATA (UNOCAL STATION TYPES A,B.C,D;E.F,G,H) Q. Periodic 0.2GPH Test Averaging... Off R. Tank Test Notify... On 1 . Peic Test Alarms Do not change from system defaults unless site has communication capability. S. Tank Test Siphon Break... Off (Turn ON if tanks are manifolded and a V/R siphon 2. Higriodh Water Alamns break valve is installed.) 3. Low Level Limit Ta T.) Delivery Report Delay... 2 minutes. Liq�l d�l° D T II sensors) USE APPLICABLE SECTIONS ONLY L4 DMFRCY ALL 4 REV DATE REVISED READINGr 'wE �. "Pero APPROVAL RECORD APPROVALS © UNION OIL OF CALIFORNIA, dba UNOCAL, 1994 A 4/24/9 6 REVISE PER COMMENTS RH m'rsI°"E °"� �°"°w ortnw a RH VEEDER ROOT SYSTEM THIS DOCUMENT AND THE INFORMATION CONTAINED HEREIN IS ISSUED FGR G.U.P. RY UNDERGROUND STORAGE TANK STANDARD CHECKED TO UNION OIL OF CALIFORNIA (UNOCAL) AND HAS ISSUED FOR PLAN CHECK BEEN FURNISHED IN CONFIDENCE AND ARE SUBJECT TO THE iwrx/rtn TERMS OF A SEPARATE SECRECY AGREEMENT BETWEEN UNOCAL ISSUED FOR GEN. BID AND THE RECIPIENT. THE RECIPIENT IS NOT TO COPY, DUPLICATE �� 4/10/96 seET OR DISCLOSE THE CONTENTS TO ANY PERSON OR ENTITY EXCEPT -- - oan�Hc „o aEveo. ISSUED FOR CONSTRUCT. AS EXPRESSLY AUTHORIZED BY SAID AGREEMENT OR BY UNOCAL PRODUCTS COMPANY J - 0 . 6 A ---- scaF NONEor sneers IN WRITING. RECORD DRAWING ( TMx' A) A B C D E IT - � f