COMPLIANCE INFO 1986-2001 - Laserfiche WebLink

Home Browse Search

' BANKS & CO ' 4.0 REMOVAL OF THE EXISTING EQUIPMENT 4.01 REMOVING THE DISPENSERS Banks & Co. will be responsible for disconnecting the existing electri- cal wiring to the dispensers and breaker panel. The dispensers will be lifted off of the islands and left at the site for disposed by the customer. ' 4.02 PURGING OF THE PIPING All piping shall be disconnected at a point farthest away from the ' tanks. Liquid inside the piping will be drained, collected and properly disposed of. Banks & Co. will drain the existing piping back into the tanks and purge the lines with nitrogen. Any remaining residue will be removed or drained into a bucket, then placed back into the u.g. tank. ' 4.03 DISCONNECTING DISPENSERS AND CONDUITS Banks & Co. will disconnect the piping unions on the product piping and ' electrical conduits. The electrical wires will be capped and taped to eliminate electrical sparks. 5.0 TESTING PROCEDURES 5.01 TESTING OF PIPING All product piping will be tested with a Campo/Miller Precision Line Tester, capable of checking the piping at a leak rate of .05 gallons per hour leak rate. 6.0 INSTALLATION OF PROPOSED EQUIPMENT 6.01 INSTALLATION OF MULTI-PRODUCT DISPENSERS (MPD) ' The proposed MPD will be set over the existing dispensers holes using a backhoe or forklift. The existing piping will be relocated with flex lines to the proposed MPD location. If piping needs to be moved more than 2 feet, galvanized metal piping will be used to make the connections. All fittings ' will be wrapped with tape to protect the piping from the environment. The dispenser piping will have to be relocated approximately four feet. The piping will be installed with galvanized metal piping The piping will be ' pressure tested with a Campo/Miller Precision Line Tester. 6.02 ELECTRICAL CONNECTIONS ' The electrical conduits will be moved to the proposed MPD location by cutting off the existing conduits and re-threading the conduit. Banks & Co. will connect to the existing conduits with rigid metal conduits and ap- propriate explosion proof fittings. Banks & Co. will pull new wires for the ' MPD and connect as required. All electrical fittings and connections will be made in accordance with N.E.C. Codes and local requirements. 6.03 LEAK DETECTORS INSTALLATION ' Banks & Co has been asked install product line leak detectors in the existing Submerged Turbine Pump (STP) . We will remove the existing plug in the existing STP and replace it with a Red Jacket Line Leak Detector (LLD) . ' 7 SITE SAFETY PLAN