Laserfiche WebLink
Procedure <br /> The following recommended procedure can be followed at the completion of the ISD system software <br /> setup: <br /> STEP 1. EVR TYPE is set to VACUUM ASSIST? <br /> a <br /> STEP 2. VACUUM ASSIST TYPE is set to HEALY VAC? <br /> O <br /> STEP 3. NOZZLE AIL RANGE MAX is set to 1.15 and MIN is set to 0.95? <br /> STEP 4. VAPOR PROCESSOR TYPE is set to NO VAPOR PROCESSOR? <br /> STEP 5. There is a wired and ENABLED"AIRFLOW METER"(i.e.ISD Vapor Flow Meter)in <br /> each vapor recovery dispenser? <br /> STEP 6. There is a wired and ENABLED"PRESSURE SENSOR"(i.e. ISD Vapor Pressure Sensor)? <br /> STEP 7. The FUEL HOSE TABLE is setup and filled out for each vapor recovery hose? <br /> STEP 8 The ISD FUEL GRADE HOSE MAP does not contain entries for non vapor recovery <br /> hoses(e.g.diesel)? <br /> STEP 9. On the TLS press the MODE key until the DIAGNOSTIC MODE menu is displayed <br /> (this will cause a TLS console System Self Test). <br /> STEP 10. 'Using the Troubleshooting Guide respond to all ISD Setup ALARMS posted on the <br /> printer tape. <br /> STEP 11. Repeat Steps 8&9 until there are no ISD setup or self-test alarms. The TLS Console <br /> display reads ALL FUNCTIONS NORMAL. ❑ <br /> Using the ISD PC Setup Tool and the ISD Vapor Pressure Sensor calibration valve: <br /> STEP 12. The ISD Vapor Pressure Sensor reads an ambient pressure reading with an offset <br /> no greater then+1-0.20 IWC? D <br /> STEP 13. Returned the ISD Vapor Pressure Sensor calibration valve so that the sensor is reading <br /> UST vapor pressure? a <br /> STEP 14. Using the ISD PC Setup Tool: <br /> An ISD AIL reading is coming in for each gas hose at the location? <br /> STEP 15. The TLS console clock is set to the correct date&time? <br /> Updated 04/05/2006 <br /> 2 of 2 <br />