INSTALL 2018 - Laserfiche WebLink

Home Browse Search

• � 1 3.07 Acceptable Products - RED THREAD IIA Piping Secondary Containment Piping System as manufactured by NOV Fiber Glass Systems or engineered approved equal. SECTION 1 - Scope This section covers the use of fiberglass reinforced plastic SECTION 4 - Installation and Testina (FRP) pipe for fuel handling and fuel handling vent and vapor 4.01 Tralnina and Certification - All joints installed or applications Including gasoline, unleaded gasoline, gasoline/ constructed in the field shall be assembled by employees alcohol mixtures, blo-diesel and diesel that require secondary of the contractor who have been trained by the pipe containment. manufacturer. The pipe manufacturer or their authorized representative shall train the contractor's employees in the SECTION 2 - General Conditions proper joining and assembling procedures required for the project, Including hands-on participation by the contractor's 2.01 Coordination - Material furnished and work employees. Each bonder shall fabricate one pipe-to-pipe performed under this section shall be coordinated with the and one pipe-to-fitting joint that shall pass the minimum related work and equipment specified under other sections, pressure test for the application as stated in Section 2.03 i.e. Valves, Flexible Connectors, Equipment. without leaking. Only bonders that have successfully completed the 2.02 Governina Standards - Except as modified or pressure test shall bond pipe and fittings. Each bonder shall supplemented herein, all materials and construction methods carry a current manufacturer's proof of training card. shall comply with and be tested in accordance with the 4.02 Pipe Installation-Pipe shall be Installed as specified following standards and test methods: and Indicated on the drawings. The piping system shall be Installed in accordance with the Standards and Test Methods: manufacturer's current published installation procedures. UL971 Standard for Nonmetallic Underground Piping for Flam- 4.03 Testing - A hydrostatic pressure test shall be 2004 mable Liquids conducted on the completed piping system. The piping system shall be subjected to 10 pressurization cycles from 0 ASTM Standard Classification for Machine-Made"Fiberglass" pslg to 1.5 times the design operating pressure as stated in D2310 (Glass Fiber Reinforced Thermosetting Resin) Pipe Section 2.03.c. After the 10 cycles, the pressure shall be held ASTM Standard practice for obtaining Hydrostatic or Pressure on the system for a minimum of 1 hour and the line Inspected D2992 Design Basis for"Fiberglass" (Glass Fiber Reinforced for leaks. Thermosetting Resin)Pipe and Fittings Test pressures shall not exceed 1,5 times the maximum rated pressure of the lowest rated element in the system. 2.03 Operatina Conditions - In addition to the above All pipe joints shall be water tight. All joints that are found listed minimum design requirements, the system shall meet to leak, by observation or during testing, shall be replaced by the following minimum operating conditions: the contractor and retested. a. Operating Pressure Should hydrostatic testing be Impractical, testing with b. Fluld Conveyed low pressure air or Inert gas may be acceptable. Extreme c. Test Pressure caution should be used when testing with air. Follow all safety precautions and testing recommendations of the pipe 2.04 Quality Assurance - Pipe manufacturer's quality manufacturer. program shall be in compliance with ISO 9001 and/or API O1. 2.05 Delivery. Storage. and Handling - Pipe and fittings shall be protected from damage due to Impact and point loading. Pipe shall be properly supported to avoid damage due to flexural strain. The contractor shall not allow dirt, debris or other extraneous materials to get Into pipe and fittings. All factory machined areas shall be protected from sunlight until installed. 2.06 Acceptable Manufacturers - NOV Fiber Glass Systems, 501-568-4010, or approved equal.