Laserfiche WebLink
D. Results of Testing/Servicing • • <br /> Software Version Installed: <br /> Co fete the following checklist: <br /> Yes ❑ No. Is the audible alarm operational? <br /> es ❑ No* Is the visual alarm operational( <br /> es ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes U* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> N/A operational? <br /> Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to opera r is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) Zf Sump/Trench Sensors; ❑Dispenser Containment Sensors. <br /> fi <br /> Did you confirm positive shut-down due to Ieaks and sensor failure/disconnection? J Yes; 13 No, <br /> ❑ Yes For tank systems that utilize the monitoring system as the primary tank overfill warning device (Le. no <br /> mechanical overfill prevention.valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s) and operating properly? If so,at what percent of tank capacity does the alarm trigger? <br /> ❑ yes* No Was any monitoring equipment replaced? If yes, Iden 1 specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Yrs* No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑ product; ❑Water. If yes, describe causes.in Section E,below. <br /> 91 es ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach setup reports,if applicable <br /> fd YesO No* Is all monitoring equipment operational per manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br />