Laserfiche WebLink
FjVEEDER-ROOT • <br /> SUMP SENSOR <br /> INSTALLATION INSTRUCTIONS <br /> NOTE: DO NOT SEAL WIRE NUT • <br /> I CONNECTION WITH EPDXY AT THIS TIME! <br /> Epoxy sealant furnished with each sump sensor LEADER CABLE <br /> should be installed only after warranty checkout by <br /> an authorized Veeder-Root TLS/ILS distributor. <br /> coo GRIP SUMP <br /> WEATHERPROOF WALL <br /> JUNCTION BOX <br /> {1 PER SENSOR) <br /> JunlcnoN eox <br /> 112"RIGID i glk <br /> CONDUIT <br /> TO <br /> TO SENSOR I <br /> MONITOR <br /> MOUNTING SLEEVE <br /> F + <br /> Wht SUMP SENSOR SWITCH <br /> Figure 2. ILS-250, TLS-250i Four-Tank (Direct-Connect), Figure 4. Mounting Sleeve Cemented to Sump Wall <br /> ILS-350 and TLS-350 System Sensor Wiring Installation <br /> Diagram <br /> NOTE: The mounting sleeve.must be mounted far <br /> It' enough into the sump to allow the sump sensor,when <br /> installed, to rest on the base of the sump and <br /> mounted at least one inch up from the base. <br /> WEATHERPROOF <br /> JUNCTION Bo% <br /> l l PEP PROBE! <br /> IT PROBE I b. Mark a line on the sump wall indicating the top of the <br /> V!'BIOlBmounting sleeve. <br /> coNouir� ; sENSaR IA <br /> BLALM <br /> + • • • BLACK <br /> Yo,� ,roR • $ENSORIB c. Apply cement approved for use with PVC and the <br /> t sump wall material generously in a line running the <br /> 3 <br /> " complete length of the sleeve. <br /> d. Using a level, position the sleeve vertically at the mark <br /> indicated on the sump wall and press it firmly to the <br /> side of the sump. BE SURE THE SLEEVE IS <br /> ESA VERTICAL. <br /> Nodule <br /> e. Hold the sleeve in position until the cement has <br /> Figure 3. TLS-250i Eight-Tank (Indirect-Connect) System <br /> hardened. <br /> Sensor Wiring Installation Diagram f, install and connect the sump sensor following <br /> instructions in Section 31. through 3.i. <br /> 4. To mount the sump sensor by cementing the PVC <br /> mounting sleeve to the sump wall (fiberglass sumps only) <br /> (Figure 4): <br /> a. Select a position for the mounting sleeve in the sump as <br /> far away from the submersible pump as possible. <br /> VEEDER-R40T <br /> Environmental Products <br /> 125 Powder Forest Drive, Post Office Box 2003, Simsbury, CT 06070-2003 EL: {203)651-2700, Ak (203)651-2750 • <br /> AUSTRALIA:Cheltenham,Victoria • BRAZIL:Sao Paulo • CANADA.Etobicoke • FRANCERungis • SCOTLAND:Dundee • WEST GERMANY:Neuhausen/FFllderPrinLed in U.S.A. <br /> VR 10/91 <br /> 576013-728 12088 Replaces 11731 <br />