Laserfiche WebLink
EED <br /> o� <br /> D. Results of Testing/Servicing R a, L <br /> Software Version Installed 133.02 Apk 2017 <br /> Com fete the following checklist: <br /> ® Yes ❑ No' Is the audible alarm operational? TH <br /> ® Yes ❑ No' I5 the visual alarm operational? � - <br /> ® Yes ❑ No' Were all sensors visually inspected,functionally tiif*d conK- -_tion)? <br /> ® Yes ❑ No' Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> openabon? <br /> ❑ Yes ❑ No' If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? <br /> ® N/A <br /> ® Yes ® No' For pressurized piping systems,does the turbine automatically shut down if the piping Secondary containment monitoring system detects a leak, <br /> ❑ N/A fails to operate,or is electrically disconnected? If yes:which sensors initiate positive shut-down? (Check all that apply) ®Sump/rmnch Sensors; <br /> ®Dispenser Containment Sensors. <br /> Did you confirm positive shut-dmn due to leaks an4 sensor failure/disconnection? ®Yes; ❑No. <br /> ❑ Yes ❑ No` For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.,no mechanical overall prevention valve is <br /> ® N/A installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating property? If so,at what percent of tank capacity <br /> does the alarm trigger? % <br /> ❑ Yes ® No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name <br /> and model for all replacement parts in Section E,below. <br /> ❑Yes` ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑Product ❑Water. If yes,describe causes in Section E,below. <br /> ® Yes ❑ No' Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> ® Yes ❑ No' Is all monitoring equipment operational per manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: 89 STP SUMP SENSOR NOT FUNCTIONING REPLACED W/ELITE IV ON SITE-PASS <br /> DIESEL DOES NOT HAVE POSITIVE SHUT DOWN, LINE TEST DONE TODAY <br /> Monitoring System Certification Page 2 of 4 2/21/07 <br />