Laserfiche WebLink
SB Series Pellethane SplitRepair Boots Installation Instructions <br /> For Encapsulation Repairs) <br /> STEP 6 Position the insert into the boot if applicable, but do not tighten `---� <br /> the clamp.This connection must remain loose through the filling k <br /> stage to allow air to escape. -- - <br /> STEP 7 Fill the boot with either Parasealant 626, or Bostik 1100FS <br /> through the fill tube with the Blueline pneumatic dispensing gun j <br /> until the entire cavity is full. This will ensure that the sealant <br /> pushes back through the leak point and stops the leak. <br /> .r <br /> rw <br /> } <br /> STEP 8 Once the boot is full, tighten clamps and allow sealant to fully <br /> cure. The sealant will gradually continue to cure up inside the <br /> boot and around the flange over the next 2448 hours. However, <br /> you may start hydrostatic testing immediately as the repair is " <br /> complete. <br /> BLUELINE • • 2001 • 310-3848 <br />