COMPLIANCE INFO 2010 - 2011 - Laserfiche WebLink

Home Browse Search

4. A safety person must be available to assist (lac .l'echniciatt at all titnes. This person `. must be clean shaven (fir respirator) and able to speak English. This person must have no other duties other than assisting and monitoring the Techrtician. This person is supplied by the owner or contractor. The same sataty person should be assigned cacti day. This Will minimize the time required instrucling the safety pa-son on proper procedures and policies. NOTE. The ,safety person MUST have completed 40 HOURS OF TRAINING IN TILE FIELD APPLICATIONS OF HEALTU AND SAFr4,]'V IN COMPLIANCE WITH OSHA 29 CPR 1910.120 (HAZWOPER). 5, A'o T'rrel deliveries can be inade to any (atilt onsite while the 1"echnician is inside a tank. G. when tank entry is required by the Techatician. a person trained in C:PR mw;t be beside the entry hole at all times when the Technician is inside the tank. 'This person is in addition to the safety person. If one.is not available fixnn the contracting crew. an off duty fireman, nurse, EMT, or equivalent is acceptable. Besides administecing CPR, the person will assist the safety person should an emergency rescue be required. 7. Out,Technician will perform an air/soap tightness test confirming his repairs to the exterior of tank. and possibly identify any other poleutial problems on the exposed areas of the tattle. All efforts must be made to isolate. disconnect, or plug all the piping on tank. if this test is done, and at a later date another problem with the tank is identified, it will he the financial responsibility of the owner or contractor to schedule a return trip to the site. R. It is important that the contractor or owner contact the appropriate local and state authorities lbr regulations concerning the jobsitc. Jobsite permits may need to be obtained for the excavtttion or remanufactilre of the tank. Permils rrrusi be abtained by tine owner/contractor prior to our arrh al. Rek;ulatians governing testing of underground tanks should he determined so Technician can be advised. r 9. The contractor must disconnect the electrical supply and remove the pump from the tank. The product line at the pump must also be disconnected or capped. This will insure no fuel can enter the tank while Technicim) is working. I0. The water table in the tank hole must be controlled of all times. The Technician is unable to remanu:facture interior or exterior surfaces if they are wet. Controlling the water table will also prevent the tank from Floating. I I., It may be required, Por Tanks to be entered to be triple rinsed prior to 'Technician's arrival. Check with local regulators to see if required. v cllll'Y ltPO