Laserfiche WebLink
130312-737 <br /> D. Results of TestinglServlcing <br /> Software Version Installed: N' A <br /> Complete the following checklist: <br /> x Yes Q No" Is the audibte alarm operational? <br /> x Yes No' Is the visual alarm operational? <br /> x Yes W No' Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> R YesU No' Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their <br /> proper operation? <br /> 0 Yes No' If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modem)operational? <br /> [5 N/A <br /> Yes No' For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system <br /> R NIA detects a leak,fails to operate,or is electrically disconnected? If yes:which sensors initiate positive shut-down? (Check ali that apply) <br /> E]Sump/Trench Sensors; Dispenser Containment Sensors- Did you confirm positive shut-down due to leaks and sensor <br /> fad ureldisconnection? Yes; No. <br /> x Yes No" For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.no mechanical overfill prevention <br /> NIA valve is installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,a1 what percent <br /> of tank capacity does the alarm trigger? 9{r% <br /> Yes' x No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br /> manufacturer name and model for all replacement parts in Section E,below. <br /> x Yes` No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply)p Product; 0 Water. If <br /> s,describe causes in Section E,below. <br /> x Yes U No' Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,it applicable <br /> x Yes No' Is all monitoring equipment operational per manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> I? Comments: <br /> A small amount of condensation was found in the North Turbine sump. It was <br /> not enough to place the sensor in alarm. It was removed. <br /> Monitoring System Certification gage 2 of 4 12W <br /> 2 2/21107 <br />