Laserfiche WebLink
C - FIBERGLASSINO'THE BASE TO TANK COLLAR. <br /> ENSURE THAT THE SUMPS ARE COMPLETELY DRY, FREE OF <br /> DEBRIS, ICE AND/OR SNOW. DO NOT HANDLE ANY FIBERGLASS <br /> SUMP WITH YOUR BARE HANDS. <br /> C.1 - Pre-cut several dozen pieces of 6" wide fiberglass mat to lengths of 20-24". You will need <br /> 4 layers of these fiberglass mat strips for the INSIDE and OUTSIDE joints of each piping sump. <br /> C.2 - Mix together resin and catalyst with mix stick thoroughly. <br /> I For SUMMER!! 1/4 bottle per 1/4 Gallon of resin. <br /> ® For WINTER!! 1/2 bottle per 1/4 Gallon of resin. <br /> C.3 - Use paint roller to apply resin generously to a smooth surface. <br /> Spread the resin so it 'wets out' an area larger than the strip of fiberglass <br /> mat. (Fig. C.3) <br /> M <br /> C.4 - Apply one layer of fiberglass mat to the resin and use the paint <br /> roller to add more resin to fully saturate it. (Fig. C.4) <br /> C.5 - Lay down another strip of fiberglass mat, staggering the new layer Y <br /> ONE INCH. This means to offset the next fiberglass strip horizontally <br /> (lengthwise) 1" to the right. Roll more resin into the new strip to saturate it. <br /> (Fig. C.5) <br /> � Fig. C.5 <br /> C.6 - Repeat Step C.5, offsetting another <br /> strip of fiberglass mat and using the paint <br /> roller to add more resin to it until it is fully <br /> saturated. (Fig. C.6) <br /> C.7 - Repeat once more Step C.5 for avn <br /> total of 4 layers. <br /> Fig. CA - <br /> C.8 - Use a Chamfer roller to completely Fig. cs' <br /> roll over the pre-soaked fiberglass strip while it is on the cardboard, hori- <br /> zontally and vertically, <br /> to run out any air bubbles. (Fig. C.6) <br /> C.9 - Apply the fiberglass patch to the OUTSIDE JOINT of the piping <br /> sump centered on the joint. Apply saturated fiberglass strips all the way <br /> around the piping sump....EVENLY OVERLAPPING EACH 2 FOOT <br /> STRIP 3 INCHES OVER THE LAST. (Fig. C.9.1) <br /> 9 ii-B401-D W-S P-10A <br />