Laserfiche WebLink
FROM : OIL EQUIPMENT PHQNF NO, : 209 7545726 Nov. 21 2001 10:35AM P6 <br /> • <br /> WESTERN FIBERGLASS 1-800-688-3375 <br /> DISPENSER MOUNTINGASSEMBLY(DMA )INSTALLATION INSTRUCTIONS <br /> The DMA is a simple design that incorporates either a fiberglass or a poly-composite leak containment <br /> sump,U.L.Listed independent dispenser base anchor and safety valve mounting systems into one <br /> complete unit. The DMA is supplied with a containment sump unit,pre installed mounting assemblies <br /> for emergency valves,and concrete mounting anchors for each dispenser anchor bolt. (According to <br /> dispenser model#) <br /> I1"QRTANT!111 READ ALL INSTRUCTIONS PRIOR TO BEGINNING INSTALLATION <br /> Options <br /> Additional options are the SplashGardm rain and wash-down water shield,FlashGard" a flame <br /> suppressant and the Retro-Fit Bracket System Custom mounting plates or other devices available. <br /> Dispenser Base Anchors <br /> The dispenser mount anchor is a 2"x'/2"threaded coupling with two V x'/s"bolts,and one 1"x 3"x <br /> 100 ml steel concrete anchor bar.This anchor assembly is mounted in the dispenser base mount <br /> position(s),based on dispenser make and model W on the flange of the DMA before pouting concrete.If <br /> not pre-installed from factory,install the 1"xt/z"bolt and 1"x 3"anchor bar into one end of the coupling. <br /> Pot the other 1"x'/2"bolt into the other end of the DMA box at the correct dispenser mount positions. <br /> When concrete is poured,this assembly will be anchored into the concrete.After the concrete has cured, <br /> remove the 1"x'/z"bolts from the top of the DMA flange and use them to mount the dispenser.The <br /> Retro-Fit dispenser base anchors are 4"X 1/2""P'bolts placed in the DMA flange prior to positioning the <br /> DMA in the island form.The Retro Brackets become anchored during the concrete pour.The"J"bolts <br /> provide a 1/2"stud for dispenser mounting. <br /> Safety/impact Valve Anchors <br /> The"UnistruC,channel mount,emergency valve mounting assembly for the DMA allows full 3-axis <br /> adjustment of the shear/safety valve.It will also allow the addition of extra shear valve brackets for future <br /> installations of different dispenser models using the same dispenser base configuration.The 3-axis <br /> channel mounting system is designed to be used with the"Boss"type safety valve mounts. <br /> The lateral channel rails have mount bolts that extend through the side of the DMA.The concrete <br /> anchor/securing bars ate attached to these bolts on the outside of the DMA(change from shipping <br /> positions if required, sce drawing).The standard concrete anchor bars have holes for a piece of re-bar <br /> on each side of the DMA box,through the anchor bars,to be installed prior to concrete pour. <br /> Note: The safety/shear valve concrete anchor bars and dispenser base anchor tabs or <br /> bolts must be in the proper position and securely in place prior to pouring concrete. <br /> Use Listed/Approved watertight penetrations or*for both the piping and conduit entry on U.L.Listed <br /> sumps,and follow the manufacturer's installation instructions. <br /> Standard Installation and Assembly <br /> Prior to installing the DMA in position in the island form,assemble the DMA unit including bolting in • <br /> the dispenser base mount anchors;moving the safety valve"Boss"mount channel brackets to the correct <br /> position and brace. You may lay a piece of flat or angled stock metal,wood or re-bar underneath the <br />