Laserfiche WebLink
Don K. Mukai <br /> MECHANICAL ENGINEER <br /> 1841 Paloma St. Pasadena, CA, 9110.4 <br /> 323-88841.36 <br /> September 4,2012 <br /> Mrs.Paola B. Recendez <br /> S.Bravo Systems,Inc. <br /> 2929 Vail Ave. <br /> Commerce,CA 90040 <br /> Re: Specification-approved by a state registered professional engineer <br /> CCR Title 23;Division 3,Chapter 16,Article 3, Section 2631(d) <br /> This letter is for an engnieering specification review and approval of a secondary <br /> containment system component which is not an integral part of primary containment for an <br /> underground fuel tank storage system in California.The authority for this approval comes <br /> from the California Code of Regulations(CCR)Title 23,Division 3,Chapter 16;Article 3, <br /> Section 2631(4). <br /> I have examined and reviewed the following specifications for the Bravo CONY Retrofit-Plate, for <br /> use in sealing the California State Approved UDSCCS(Under Dispenser Spill Containment or <br /> Control System) CONV--B2000 Dispenser Conversion Frame post-modification: <br /> 1) UL Certifications Directory MH26018 for Vipel F-764 and F-774 resins <br /> 2) AOC Vipel Product Selection Guide. <br /> .3) AOC Vipel Corrosion Resistance Guide <br /> 4) Bravo Systems Installation Guidelines draft for the CONY Retrofit-Plate <br /> Y B <br /> 5) Bravo Systems CON2000 Installation manual 12A. . <br /> 6) Bravo Systems UL Approval document UL-ULC BRAVO FSERIES <br /> 7) Bravo Systems Adhesive-Epoxy-Kit and Adhesive-Retrofit Epoxy-Kit MSDS <br /> 8) Smith Bulletin D4025 December 15,2007 <br /> 9) Smith Bulletin D4010 April 15,2007 <br /> 10) Smith Bulletin B2102 May 1,2006 <br /> This Retrofit plate system consists of a UL Listed fiberglass panel or panels and is bonded to the <br /> angled drainage panels of the CONY B2000 conversion.frame.with Bravo adhesive(ADHESIVE- <br /> RETROFIT-EPDXY-KIT). <br /> ADHESIVE- <br /> RETROFITEPDXY KIT). The product is not defined by any one size or shape.The manufacturer <br /> (Bravo)must evaluate each.case and fabricate Retrofit Plates for each application. I have observed <br /> that the dimensions of the Retrofit Plates may differ in each case since no one size will fit all <br /> applications. <br /> 3RP-CCNV-Retrofit-Plate PAGE 1 of 2 <br />