Laserfiche WebLink
r <br /> 522 Remote Monitor Input/output <br /> r <br /> r <br /> r <br /> r <br /> Use 2 outer positions on terminal block for output from N/C Relay. <br /> Al. Input to 522 Remote Monitor B1. Output from N/C Relay: 3 Position terminal block <br /> Pauet: 5 Position connector from Domo- shown above is connected to N/C Relay. Use the 2 outer <br /> sys wall mount transformer is connected to terminals as shown above. Relay opens when Fuel,or High <br /> 5 position header shown above. Water occurs. If connecting to a third-partymonitor,use 2 <br /> conductors(I8 gauge or higher)long enough to connect to <br /> Make connections prior to mounting 522 appropriate interface module. Make connections prior to <br /> Remote Monitor Panel. installing 522 Remote Monitor. <br /> r <br /> A2. WOO to Serial Relay Interface: B2. Output from N/C Relay: Insert conduc- <br /> Alarm data is transmitted to the 522 Serial tors to third party monitor interface module <br /> Interface System(if being used)from the 9- here. Use 2 outer positions on terminal block <br /> pin female D-Sub connector. The 522 Serial <br /> Interface system has a harness terminated <br /> with a 9-pin male D-Sub connector— <br /> connect that harness to female D-Sub shown <br /> above. <br />