COMPLIANCE INFO 1998-2003 - Laserfiche WebLink

Home Browse Search

• 500 SERIASTALLATION INSTRUCTIONS 4. Connect and Mount Sensors A. Connecting Sensor Plugs Connect all plugs as shown below to ensure connections are made properly. Sensors can be connected to any of the female plugs on either the Y or W harness. Female Plug J Male Plug 0 a 0 m 0 To connect plugs, line up the 2 screws on the side of the plug - then push nate plug into female plug until it stops B. Mount Impact Sensor The Impact Sensor should be rigidly mounted to the dispenser frame (use two '`/<x 20 bolts)at an appropriate location above grade. The sensor must be mounted in a vertical position in order to work properly. After mounting the impact sensor, it must be reset. Remove the reset screw located in the top of the Impact Sensor—do not misplace it as it will need to be replaced. Locate the green reset tool included in the bag. Insert the tip into the reset hole andeg ntly push down—the float inside the sensor will unlatch. Pull out the reset tool and replace the reset screw. C. 510 Discriminating Sensor Locate the Model 510 Discriminating Sensor. The cap of the Model 510 Sensor must be placed onto the base—press it on so it will not come off. The Model 510 Sensor can be mounted using the SMB-500 sensor mounting bracket with the 2"pipe clamp. The bracket is designed to allow the sensor to be mounted to the U-Channel bracket at various heights. If using the fire extinguisher, the 510 Sensor should be mounted so that the fire extinguisher valve is above the top of the 510 Sensor. This will prevent the fire extinguisher valve from becoming submerged in a high-water condition. D. Other Sump Sensors If using the Model 516 Discriminating Sensor in conjunction with the 510 Discriminating Sensor, or if using the Model 406 Liquid Sensor alone,use the SMB-500 sensor mounting bracket with the 1"pipe clamp to properly position the sensor in the base of the sump. The bracket can be used to mount either one or two sensors at various heights. Page 8