Laserfiche WebLink
aJ Page 7 of 10 <br /> 7. UNDER-DISPENSER CONTAINMENT C TESTIN <br /> Test Method Developed By: ❑UDC Manufacturer ®Industry Standard ❑P f <br /> ❑Other(Specify) <br /> Test Method Used: ❑Pressure ❑Vacuum ®Hydrosta 2015 <br /> ❑ Other(Specify) <br /> Test Equipment Used: See attached testing procedures. Equipment Resoluuo v ,,. <br /> LDDC#9/10 UDC#11/12 UDC# UDC # <br /> UDC Manufacturer: <br /> UDC Material: Plastic Plastic <br /> UDC Depth: 25" 25" <br /> Height from UDC Bottom to Top 8" 8" <br /> of Highest Piping Penetration: <br /> Height from UDC Bottom to 5" 5" <br /> Lowest Electrical Penetration: <br /> Condition of UDC prior to Fair Fair <br /> testing: <br /> Portion of UDC Tested Above highest Above highest Above highest Above highest <br /> penetration penetration penetration netraaon <br /> Does turbine shut down when <br /> UDC sensor detects liquid(both E]Yes E]No N NA ❑Yes E]No N NA [:1 Yes El No N NA El Yes El No N NA <br /> product and water <br /> Turbine shutdown response time <br /> Is system programmed for fail- <br /> safe shutdown? <br /> El [:]No N NA [:]Yeses ElNo N NA ElYes ElNo N NA ElYes [-]No N NA <br /> Was fail-safe verified to be ❑ <br /> operational?* Yes E]No N NA [—]Yes[:]No N NA [-]Yes [-]No N NA ElYes ElNo N NA <br /> Wait time between applying <br /> pressure/vacuum/water and 30 minutes 30 minutes 30 minutes 30 minutes <br /> starting test <br /> Test Start Time: 2:24pm 3:05pm <br /> Initial Reading(RI): 1.3628 1.3955 <br /> Test End Time: 2:39pm 3:20pm <br /> Final Reading(RF): 1.3628 1.3956 <br /> Test Duration: 15 min 15 min 15 min 15 min <br /> Chane in Reading(Pr-R : 0.00004 0.00011 <br /> Pass/Fail Threshold or Criteria: 0.002 0.002 0.002 0.002 <br /> Test Result: Pass LJ Fail Pass all LJ Pass Ll Fail Pass Fail <br /> Was sensor removed for testing? ®Yes❑No ❑NA I NYes[:)No ❑NA ®Yes❑No ❑NA I ®Yes❑No❑NA <br /> Was sensor properly replaced and <br /> verified functional after testing? ®Yes❑No❑NA NYes[:]No❑NA NYes❑No ❑NA Yes❑No❑NA <br /> Comments— (include information on repairs made prior to testing, and recommended follow-up for failed tests) <br /> u If the entire depth of the UDC is not tested,specify how much was tested. If the answer to any of the questions indicated with an <br /> asterisk(e)is"NO"or"NA",the entire UDC must be tested. (See SWRCB LG-160) <br />