Laserfiche WebLink
Replacing Software/Memory Modules <br /> 1, Perform the "Archiving the System Setup Into the EEPROM Chip" on page 4. <br /> 2. Switch Off power to the console. <br /> 3. Open the front door of the console and locate the ECPU board Figure 1 on page 6. Figure 7 shows the layout <br /> of software module and the two memory modules (NVMEM-201 and NVMEM-203). <br /> Software Module (Front side) <br /> i <br /> Mounting notch(seats over ridge Mounting notch(seats over ridge in <br /> in base of connector-typ all boards) edge of connector)-typ all boards) <br /> U10DU12 Fi <br /> D U3 k <br /> NVMEM-201 Card (Front side) ❑ a� <br /> P/N 332966-201 <br /> (NON-ISD) <br /> O o h[] 0 0 0 <br /> 0 I I ° I ° <br /> U5 us U10 U12 <br /> O U3 <br /> NVMEM-203 Card (Front side) <br /> P/N 332966-203 <br /> (ISD) <br /> 011 I ° I ° ' 1 1 <br /> say-i.eve <br /> Figure 7- Software and Memory Module Component Layouts <br /> 4. Follow the instructions in Figure 8 to install or replace these modules. <br /> 13 <br />