Laserfiche WebLink
Replacing Software/Memory Modules on the ECPU Board Installing the ECPU Board <br /> Removing modules- <br /> Z 3 Use your fingers to spread <br /> retaining clips away from <br /> Attach one end of the the module board edges, <br /> antistatic wrist strap to tilt in the board to the front <br /> your wrist and the other of the console and lift it out. <br /> end to the bare metal <br /> base inside the console. Module retaining clips <br /> (one on each end) <br /> 0 M <br /> 1 <br /> 1999 ® Turn ac power to console OFF. <br /> 1 Push SWI down to turn <br /> battery backup OFF. <br /> Removing Software and Memory Modules <br /> Seat module in connector J1 at <br /> an angle with component side facing _4 'FF, <br /> the front of the console. Make r' <br /> sure that notch in the bottom of <br /> the board is over ridge in base of <br /> connector,then push board back <br /> until retaining clips snap around the <br /> board's edges.DON'T FORCE BOARD <br /> or you may damage socket! Check <br /> that notch and ridge are aligned <br /> correctly then try again. �t i ECPIJ board <br /> Retaining clip(2) <br /> Front of console Jl J2 <br /> View A-A(above) <br /> Installing Software and Memory Modules <br /> 83]-2.epa <br /> Figure 8. Removing and Installing a Software or Memory Module <br /> 5. Perform a cold boot as described in "Performing a Cold Boot" on page 11. <br /> 14 <br />