Laserfiche WebLink
Installer Menu Page 7/12 <br /> Install PIN PIN XXXX can be changed <br /> 'Error"is displayed if the entered PIN number Input new PIN <br /> has already been allocated to another operator. <br /> Installer <br /> PIN: XXXX <br /> Enter the PIN number and confirm with"OK" <br /> or return with"Quit". <br /> Hose Calibration Calibration or scale factor for each hose(meter). CF= t Product: <br /> (Flowmeter K- 100/x-factor. For example,for flowmeter with K-factor of 251 Select <br /> factor) pulses/gallon,CF=100/251 =0.3984. Enter without decimal Tankl Tank2 2 <br /> point as: <br /> Tank3 3 <br /> CF:03984 Inactive 4 <br /> Select a Tank and confirm with'OK" <br /> or return with'Quit". <br /> ----------------- <br /> Enter the calibration factor and confine with'OK" CF: 03984 <br /> ----------------- <br /> or return with'Quit". Cal.Constant <br /> 0.000001L/Puls <br /> Ignore the"Cal Constant"below the CF. <br /> "THE SAME CF MUST BE ENTERED FOR EACH TANK" <br /> Hose Offset Can correct for over delivery caused by aslowvalve. The t Product: <br /> (Tank fJffset) Calibration Offset(CO)is in tenths of gallons. For example,if Select <br /> system is delivering 2.91 gallons when calculated amount is Tankl <br /> 2.86 gallons,an offset of 0.05 gallons is entered as: Tank2 2 <br /> Tank3 3 <br /> CO:050000 Inactive 4 <br /> In this example,the system will close the valve when the <br /> dispensed volume reaches 2.82 gallons. The overrun due to <br /> the slow valve will result in the correct dispense of 2.87 ----------------- <br /> gallons. <br /> _____gallons. CO: 000000 <br /> ----------------- <br /> Select a Tank and confirm with'OK" Cali.Offset <br /> or return with'Quit". (0.000001L) <br /> Ester the hose offset(CO)and confine with'OK' <br /> or return with'Quit'. <br /> "THE CO MUST BE ENTERED FOR EACH TAN K" <br /> Print Parameter Will print the cu hent configuration an the specified printer No sub menu. <br /> for each Tank. <br /> Setup Printer Printer selection Printer: 1 <br /> 0:No printer assigned _________________ <br /> 1:Internal printer non 0 <br /> 2:External printer Internal 1 <br /> 3:Internal and external printer <br /> External 2 <br /> Int.& Ext. 3 <br /> LMS_Baby System <br />