SR0079782 - Laserfiche WebLink

Home Browse Search

SINGULRIR o OPERATING CONDITIONS Total holding capacity of the system shall provide a minimum of 48 hour retention of the daily flow. The pretreatment chamber shall provide at least 18 hour retention,the extended aeration chamber shall provide at least 24 hour retention and the clarification chamber shall provide at least 6 hour retention. The non-mechanical flow equalization device shall increase each individual chamber and total system retention time in direct proportion to loading. Design of the system shall include a compartmented tank and non-mechanical flow equalization device to insure successful treatment performance without upset even when the significant runoff period is six hours. Hydraulic design considerations of the system and flow equalization device shall be such that intermittent peak flow factors as high as four shall not upset hydraulic reliability within the system. System performance in compliance with the requirements of NSF Standard 245 shall be recognized by an ANSI accredited third-party laboratory and be approved for use by the local governing regulatory agency. PRETREATMENT CHAMBER The pretreatment chamber shall be an integral part of the wastewater treatment system. All domestic wastewater shall be preconditioned and flow equalized while passing through the pretreatment chamber prior to being introduced to the extended aeration chamber. The outlet of the pretreatment chamber shall be equipped with a discharge tee that extends vertically into the liquid so that only the preconditioned equalized flow from the center area of the chamber is displaced to the extended aeration chamber. The discharge tee and transfer port shall be of adequate size to handle a peak flow factor of four without restricting the outlet and disturbing hydraulic displacement to the extended aeration chamber. A removable inspection cover shall be cast into the top of the pretreatment chamber to allow tank and transfer tee inspection. As a safety measure,the uncovered opening shall be small enough to insure that the tank cannot be entered for inspection or service. ALTERNATE INLET REMOVABLE INSPECTION COVER LOCATION III WITH CAST-IN-PLACE HANDLE I r— —_—_--T_I 7f 7 AERATOR MOUNTING CASTING CAST-IN-PLACE PRETREATMENT I I i� AND COVER WITH FRESH AIR CHAMBER TRANSFER TEE i VENT ASSEMBLY II II I I II II / I BIO-KINETIC SYSTEM PRETREATMENT ] CHAMBER — III �I I Ixi �7i1 1 li—�i I 1 I Cd INLET LINE I I BIO-KINETIC SYSTEM MOUNTING I CASTING AND COVER ALTERNATE INLET _ _________1L___ LOCATION BIO-STATIC SLUDGE II RETURN EXTENDED AERATION PLAN VIEW FINAL CLARIFICATION CHAMBER CHAMBER AERATION CHAMBER The extended aeration chamber shall provide in excess of 24 hour retention of the equalized daily flow. The chamber shall be of sufficient size to provide a minimum of 80 cubic feet of tank capacity per pound of applied BOD. The aeration chamber length-width-depth ratio shall be designed to insure uniform tank mixing and provide optimum treatment. The aeration chamber(s) shall be an integral part of the system flow path and constructed of properly reinforced 5,000 PSI,28 day compression strength precast concrete. All castings used to construct the precast concrete tankage shall be monolithic units with external and internal walls incorporated into each section.